Changing The Battery Pack - Festool BHC 18 Li Manual De Instrucciones

[1-6] Belt clip
[1-7] Battery pack
[1-8] Button for releasing the battery pack
[1-9] Capacity display
[1-10] LED lamp
[1-11] Auxiliary handle
[1-12] Depth stop
[1-13] Insulated gripping surfaces (grey shaded area)
[3-1] LED-Display
[3-2] Cable holder
[4] Wall mount for charger
The specified illustrations appear at the beginning
of the Operating Instructions.
6 Operation
WARNING
Unauthorised voltage or frequency!
Risk of accidents

Observe the specifications on the machine's
name plate.

Observe country-specific regulations.
6.1 Charger cable holder [3-2]
Unwind the cable completely from the recess
before using the charger.
6.2

Changing the battery pack

Inserting the battery pack [2 A]
Removing the battery pack [2 B]
6.3 Charging the battery pack [3]

The battery pack is delivered partially charged.
Charge the battery pack completely before us-
ing for the first time.
The LED [3-1] on the charger indicates the respec-
tive operating status of the charger.
LED yellow - lit continuously
Charger is ready to use.
LED green - flashes quickly
Battery pack is charged to maxi-
mum capacity.
LED green - flashes slowly
Battery pack is charged with
reduced current. Li-ion is
charged to 80 %.
LED green - lit continuously
Charging is complete or is not
restarted as current charge sta-
tus is greater than 80%.
LED red - flashes
General fault indication, e.g.
incomplete contact, short circuit,
defective battery pack, etc.
LED red - lit continuously
Battery temperature is outside
the permitted range.
6.4 Light and battery capacity indicator
The LED on the lamp [1-10] is both a light
and a battery capacity indicator [1-9].
The LED automatically indicates the charging
state of the battery pack (not NiCd and NiMH bat-
tery packs) when the on/off switch [1-4] is pressed.
LED green – lit continuously:
charged > 60 %
LED green – flashing slowly:
charged 30 % – 60 %
LED green – flashing quickly:
charged 0 % – 30 %
LED yellow – lit continuously:
battery is empty
LED red – lit continuously: bat-
tery, electronics or motor tem-
perature is outside the
permitted range.
LED red – flashing: indicates a
general fault, e.g. incomplete
contact, short circuit, battery
pack faulty, etc.
7 Settings
7.1 Changing direction of rotation [1-3]
• Switch to the left = clockwise rotation
• Switch to the right = counterclockwise rotation
7.2 Selecting the operating mode
Hammer drilling
Set selector switch [1-5] to hammer sym-
bol.
Screwdriving/drilling
Set selector switch [1-5] to drill symbol.
BHC 18
GB
15