Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Random programme (RND)
This special operation programme performs random connections and disconnections and is intended to use with lights as a
dissuasive measure against thieves. This programme can be manually changed to switched ON "" or switched OFF "
Two possible random operation modes are available:
a)
Not assigning Switch ON times
The random programming periods automatically oscillate between a minimum of 5 min to a maximum of 60 min (for connection
periods) or 30 min (for disconnection periods).
a)
Assigning connection periods
The connection times assigned to the RND function define the beginning and end of the random programme. The connection
periods are the same as described above. The connected lights only switch ON /OFF randomly during the indicated period.
In order to enter the beginning and end of the random programme, the same process as described in "Command programming"
must be followed. The "RND" button has to be pressed after entering the day, hour, minute and the corresponding channel for
the command.
ATTENTION: When the RND programme ends, the switch of the corresponding channel may be ON or OFF. Therefore, it is
advisable to enter an additional command after the RND period to ensure that the connected devices stay at in a known status
each time the random programme ends.
Holiday programme
The clock can be programmed to execute stored commands during a time period defined as holiday season. It must be considered that:
a)
The holiday period has a higher priority than the standard programme
b)
The operating mode of the holiday period can only be assigned to programmed commands that execute each weekday
c)
The holiday programme only activates if the length of the holiday season (1 to 99 days) has been previously defined or if it has
been defined as unlimited.
d)
The holiday programme can be initiated during the current day or it can be programmed to start at one of the six following
days
In order to enter the connection and disconnection times of the holiday programme, the same process as described in "Command
programming" must be followed. The "
for the command.
Programming the start and duration of the holiday programme
Once the commands to be executed during the holiday period have been entered as described in the above paragraph, the holiday start
and length have to be programmed. For that purpose it is absolutely necessary to press the
current time.
These steps have to be followed:
a)
Programming an unlimited holiday period
1.
Press the button with the "
2.
Press the
MRP2
6/7
" button has to be pressed after entering the day, hour, minute and the corresponding channel
" symbol: the cursor below the current day will flash.
""
button once. The programming procedure for an unlimited holiday period has finished.
""
button, so the display shows the
www.audiovias.com
O
".
50.0048.0200
Publicidad
Tabla de contenido
