Contrast Setting; Display Status Messages - Lenze EEPM1RA Instrucciones De Funcionamiento

Operation
4.14 Contrast setting
With this function, you can adjust the viewing angle for the EPM Programmer display.
Press
1.
ON
2.
ENTER
3.
ENTER
4.
5.
ENTER
6.
MENU
4.15 Display status messages
With this function, you can set the Programmer's password and view other important information.
Press
1.
MENU
2.
ENTER
3.
4.
5.
6.
7.
8.
MENU
18
The display shows...
DISPLAY CONTRAST
CONTRAST MEDIUM
CONTRAST MEDIUM
CONTRAST XXXXX
CONTRAST LOW
DISPLAY CONTRAST
The display shows...
MISCELLANEOUS
S/W VERSION X.XX
INTERN CFG 400
FILES: 1
BATTERY: 5.8VDC
PASSWORD: 0000
MISCELLANEOUS
ENGLISH
Explanation
Press the key until the menu appears in the display.
The currently set value is indicated (e.g. MEDIUM). .
The cursor is blinking in the display on the right.
Select the setting wanted:
CONTRAST LOW
CONTRAST MEDIUM
CONTRAST HIGH
The setting selected (e.g. LOW) is accepted. The
cursor stops blinking.
Returns to the main menu..
Explanation
Press the key until the menu appears in the display.
Takes you to the submenu. The software version
(e.g. 1.00) of the EPM programmer is displayed.
With the you can select the status messages.
Shows the parameter version that the EPM
programmer is configured for (e.g.400).
Indicates the number of parameter files saved in the
EPM programmer.
Displays the current voltage level of the 4 internal
batteries. To guarantee safe operation, the battery
voltage must not fall below 3.6 VDC.
Displays the set password for the access protection
(Lenze setting: 0000), entering and changing the
password is described in the next section.
Returns to the main menu.