Troubleshooting Guide - babymoov Premium Care Instrucciones De Uso

Ocultar thumbs Ver también para Premium Care:
Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 20
NIGHT LIGHT BRIGHTNESS ADJUSTMENT
REPLY TO BABY
Problem
No sound on the receiver
Transmission always on
Audible alarm
permanently activated
Always showing low battery alert
Battery life is short
Communication is frequently
interrupted or off
VOX
x1
5
TROUBLE SHOOTING GUIDE
Possible cause
• The microphone's sensitivity is too low.
• The receiver volume is too low.
• The power adapter is not properly connected.
• VOX mode active.
• The batteries are empty.
• The VOX mode sensitivity is too high.
• VOX mode is not activated.
• The receiver batteries are empty/dead.
• Distance between baby and parent unit exceeds
the operating range.
• Battery has run down.
• The battery is damaged or empty.
• Night light is permanently switched on.
• Vibration alert is switched on.
• The transmitter and/or receiver are located near
other electrical appliances.
• Using the babyphone on a power strip.
• The two appliances are separated by metal
structures, thick walls, floors, etc.
• Baby unit battery has run down.
BABY MONITOR PREMIUM CARE • Instruction manual
SETTINGS
NIGHT LIGHT VOX
RECEIVER VOLUME
x6
VOX
Solution
• Increase the microphone sensitivity.
• Increase the receiver volume.
• Check the connection.
• Press a button to activate the screen.
• Charge your receiver or replace the batteries
in the transmitter or plug the units into
the mains.
• Activate and/or adjust the VOX sensitivity (19).
• Replace the batteries in the transmitter or plug
the transmitter into the mains.
• Move the baby & parent unit closer together.
• Recharge battery using AC adapter
(parent unit).
• Replace with new battery or use AC adapter
(baby unit).
• Replace with new battery pack.
• Switch off night light or set to VOX operate.
• Switch off vibration alert.
• Move the transmitter and/or receiver away
from sources of interference or re-set
the pairing.
• Do not connect your baby monitors to
power strips.
• Re-locate baby or parent unit.
• Replace with new battery or use AC adapter.
11

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

A014204

Tabla de contenido