Troubleshooting Guide - babymoov Expert Care Instrucciones De Uso

Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 15
A. NIGHT LIGHT VOX
D. NIGHT LIGHT BRIGHTNESS
ADJUSTMENT
X 1
Problem
No sound on the receiver
Transmission always on
Audible alarm
permanently activated
Always showing low battery alert
Battery life is short
Communication is frequently
interrupted or off
8
B. VOX SENSITIVITY
E. THE RECEIVER VOLUME
X 5
TROUBLE SHOOTING GUIDE
Possible cause
• The microphone's sensitivity is too low.
• The receiver volume is too low.
• The power adapter is not properly connected.
• VOX mode active.
• The batteries are empty.
• The VOX mode sensitivity is too high.
• VOX mode is not activated.
• Transmitter battery is run down.
• Distance between baby and parent unit exceeds
the operating range.
• Battery has run down.
• The battery is damaged or empty.
• Night light is permanently switched on.
• Vibration alert is switched on.
• The transmitter and/or receiver are located near
other electrical appliances.
• Using the babyphone on a power strip.
• The two appliances are separated by metal
structures, thick walls, floors, etc.
• Baby unit battery has run down.
BABY MONITOR EXPERT CARE • Instruction manual
OPERATION
X 1
C. NO VOX
X 4
F. VIBRATOR
X 5
Solution
• Increase the microphone sensitivity.
• Increase the receiver volume.
• Check the connection.
• Press a button to activate the receiver.
• Charge your receiver or replace the batteries
in the transmitter or plug the units into
the mains.
• Reduce the sensitivity of the VOX mode (2).
• Activate the VOX sensitivity (2).
• Replace the batteries in the transmitter or plug
the transmitter into the mains.
• Move the baby & parent unit closer together.
• Recharge battery using AC adapter
(parent unit).
• Replace with new battery or use AC adapter
(baby unit).
• Replace with new battery pack.
• Switch off night light or set to VOX operate.
• Switch off vibration alert.
• Move the transmitter and/or receiver away from
sources of interference or re-set the pairing.
• Do not connect your baby monitors to
power strips.
• Re-locate baby or parent unit.
• Replace with new battery or use AC adapter.
X 5

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

A014303

Tabla de contenido