Braun Aromaster KF 400 Instrucciones De Uso página 4

Ocultar thumbs Ver también para Aromaster KF 400:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Caution
Read all instructions carefully before using this
product.
Keep this appliance out of children's reach!
Before plugging into a socket, check whether your
voltage corresponds to the voltage printed on the
bottom of the appliance.
This appliance has a polarized plug (one blade is wider
than the other). As a safety feature, this plug will fit in
a polarized outlet only one way. If the plug does not fit
fully in the outlet, reverse the plug. If it still does not fit,
contact a qualified electrician. Do not attempt to
defeat this safety feature.
The hotplate heats up when the appliance is switched
on. Avoid touching it and never let the cord touch it.
The cord of this appliance can only be changed by an
official Service dealer, since it requires a special tool.
Important
This appliance was constructed to process normal
household quantities. Always use cold water to make
coffee. Warm water or other liquids could cause
damage to the coffeemaker.
Before using the first time, or when the coffeemaker
has not been used for some time, fill the water
container to the maximum level with cold water (i.e.
without coffee grounds and without a paper filter) and
allow to flow through. The coffeemaker is equipped
with a cord storage facility
Maximum cups
10 cups (0.125 l/20.3 fl. oz each)
Filling with coffee grounds
Swing out the filter basket
filter. Put coffee grounds (not ground too finely) into
the paper filter
3
and close the filter basket again
letting it snap in place.
Measure coffee grounds according to strength
desired.
Filling with water
Pour cold water into the water container to the
number of cups desired
in the container
).
4
Note: The scale divisions on the glass carafe indicate
the amount of coffee that will be brewed. The
difference between the scale divisions on the carafe
and the cup measuring scale inside the water
container is due to the amount of moisture remaining
in the coffee grounds.
Switch
On/off switch
6
On =
(pilot light lights up)
Off =
Making coffee
Switch the coffeemaker on (see «Switch»).
Brewing time is approx. 1 minute per cup.
The «drip stop» prevents dripping when lifting off the
carafe or opening the filter basket.
4
1
.
and insert a No. 4 paper
2
5
(see cup measuring scale
To make coffee, the carafe with the lid on must be set
on the hotplate and the filter basket must be snapped
in place (due to the «drip stop»). If you should forget to
do so, a built-in overflow feature will protect the filter
basket from overflowing.
Remove the filter basket to empty grounds (8) (see
«Cleaning»).
Keeping the coffee hot
The carafe rests on a hotplate that starts to heat up
when the coffeemaker is switched on; it stays turned
on until the coffeemaker is switched off (pilot light
goes out).
The appliance is protected against overheating by
several special safety components.
Cleaning
Always pull the plug out of the socket before cleaning.
The appliance must never be cleaned under running
water and must never be immersed in water. Swing
out the filter basket, push up, then pull off downward
diagonally
8
. To replace, insert the top first. To clean,
take the lid off the carafe
The glass carafe, the lid and the filter basket can be
washed in the dishwasher. Clean all other parts with
a damp cloth only. Put the lid back on the carafe
Clean the hotplate with liquid cleansers only. Do not
use abrasive cleansers.
Decalcifying
If you have hard water, decalcify the appliance
occasionally. The frequency depends on the hardness
of your water and how often you use the coffee maker.
Whenever your coffeemaker takes much longer than
normal to brew, the appliance should be decalcified.
To decalcify your Braun coffeemaker, only use straight
2
,
vinegar (in 5 % solution). Pour 1/2 liter of straight
vinegar into the water container.
Set the glass carafe with lid on the hotplate, snap the
filter basket (without paper filter) in place and switch
on the appliance. Let half of the straight vinegar flow
through. Switch off the appliance and leave for about
10 minutes. Then switch on the appliance again
allowing the residues to flow through.
Repeat this procedure as many times as necessary
until the flow rate returns to normal (approx. 1 cup/
minute). Use a clean vinegar solution for each cycle.
Run two cycles of clean water through the unit to
return to normal.
Subject to change without notice.
7
.
7
.

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Aromaster kf 420Aromaster kf 324085

Tabla de contenido