HoMedics Envira Station DWS-220 Manual De Instrucciones E Información De Garantía página 3

DWS-220SP-ENG.qxd 10/12/04 11:34 AM
Now you will select the calendar settings-
3. Select Year - Use the " + , - " buttons located on the back of the home receiver to
adjust year setting. Press " SET " button to confirm.
4. Select Month/Day - Use the " + , - " buttons located on the back of the home
receiver to adjust month/day setting. Press " SET " button to confirm.
5. Select Hour/Minute - Use the " + , - " buttons located on the back of the home
receiver to adjust hour/minute setting. Press " SET " button to confirm.
6. DST On/Off (Daylight Savings Time) - Use the " + , - " buttons to turn DST on or off.
Press " SET " button to confirm.
FAHRENHEIT/CENTIGRADE SELECTION
You can now select either Fahrenheit or Centigrade temperature readings. Hold the
max/min button for 3 seconds to toggle between Fahrenheit or Centigrade readings.
ALARM FUNCTIONS
TO SELECT BETWEEN ALARM 1, ALARM 2 OR ALARM OFF
Press " +/ " button on the back of the unit to scroll through selections.
For Daily Alarm - The appropriate " " icon will appear in the upper left corner
of the time display.
No Alarm - The " " icons will not be shown.
TO SET ALARM TIME
1. Press "ALARM" button once to select Alarm 1 or twice for Alarm 2.
2. Once you select the correct alarm, hold the "ALARM" button down for 3 seconds.
3. Set alarm time - Press " + , - " on the back of the unit to enter the desired Hr/ Min
values. Press "ALARM" to confirm.
4. To view alarm time - Press "ALARM" button. Alarm time will display for 5 seconds
and then resume to normal clock thereafter.
5. The home receiver will provide either a daily alarm, which last for 2 minutes or a
snooze mode where the alarm will repeat every 5 minutes until manually cleared
(see SNOOZE/LIGHT section below.)
6. To turn ringing alarm off - Simply press the button under the LCD display.
The alarm is now off for one day.
SNOOZE/ LIGHT
1. Press the SNOOZE/ LIGHT button for an extended backlight.
2. In snooze alarm mode, press this button to trigger a repetitive snooze alarm.
Page 5
4
MIN/ MAX MEMORY SETTINGS
1. Press "MIN/ MAX" button to view the maximum values for
5 seconds. Press again to view the minimum values.
2. To clear the memory record, press "CLEAR" button on
the back of the unit while the respective values are
displayed on screen.
TEMPERATURE TREND INDICATOR:
Next to each weather reading on the home receiver LCD
display, you will see one of 3 icons;
will indicate Rising Conditions if it changes more than
1 degree in an hour
will indicate Steady Conditions
will indicate Falling Conditions if it is more than
1 degree in an hour.
WEATHER FORECAST WITH STORM ALERT
The built-in sensor will read the atmospheric pressure and
calculate the weather conditions of the next 12 hours. These
conditions will be displayed as; Sunny, Partial Sunny, Cloudy,
Rainy, Stormy or Icy at the top of the LCD display.
OFFSETTING AIR PRESSURE FOR
WEATHER FORECAST
After the initial step or in case the weather forecast deviates,
you can still recalibrate the unit.
1. Hold "CLEAR" button for 3 seconds to enter the pressure
offset mode. The weather icon will flash.
2. Select the existing weather condition by pressing
"MAX/MIN" button.
3. Press "CLEAR" to confirm and exit.
4. The unit is now calibrated to the existing pressure and
weather conditions.
5