Main Mix Level - LD Systems LD LAX Serie Manual De Usuario

CONTROL ELEMENTS:
10
LEVEL
The LEVEL control determines the level of the channel signal in the main mix
11
MAIN OUT
The MAIN OUT connectors are unbalanced mono connectors.
12
CD / TAPE
INPUT
The CD/MP3/TAPE INPUTS are used to bring an external signal source (e.g. CD player, tape deck, etc.) into
the console. They can also be used as a standard stereo line input, so the output of a second LAX Mixer.
OUTPUT
These RCA connectors are wired parallel with the MAIN OUT. Connect the inputs of a computer sound card or
a recorder here. The output signal level is setup using the highly accurate MAIN MIX fader.
13
PHONES
6.3 mm stereo jack for headphones.
14
PHONES LEVEL
CONTROL ROOM LEVEL (EXCEPT LAX 502)
Use the PHONES / CONTROL ROOM level to adjust the signal level of the PHONES / CONTROL ROOM output.
15

MAIN MIX LEVEL

Use the MAIN MIX level control to adjust the signal level of the MAIN MIX outputs.
16
PHANTOM POWER
Phantom power is required to operate condenser microphones and is activated using the PHANTOM POWER
switch. (only available for XLR-Mic input)
17
+48V PHANTOM POWER LED
The +48 V LED lights up when phantom power is turned on.
-Caution! You must never use unbalanced XLR connectors (PIN 1 to 3 connected) on the MIC input connec-
tors if you want to use the phantom power supply.
-Please do not connect microphones to the mixer (or the stagebox/wallbox) as long as the phantom power
supply in switched on. Connect the microphones before you switch on the power supply. In addition, the
monitor/PA loudspeakers should be muted before you activate the phantom power supply. After switching on,
wait approx. one minute in order to allow system stabilization.
18
CD/TAPE TO PHONES
CD/TAPE TO CONTROL ROOM (EXCEPT LAX 502)
Press the CD/TAPE TO PHONES / CONTROL ROOM switch if you want to monitor the 2-track input via the
PHONES OUTPUT and CONTROL ROOM OUTPUT.
10