DeWalt DWE315 Manual De Instrucciones página 8

INSTALLING/REMOVING SANDING
SHEETS (FIG. 5)
A diamond shaped platen uses a hook
and loop adhesion system to attach the
sanding sheets. The platen allows you
to use it on large flat surfaces and tight
spots or corners.
1. Attach the sanding platen (I) as
described under Installing/
Removing Accessories.
2. Align the edges on the sanding
sheet, with the edge of the sanding
platen and press the sanding sheet
(J) onto the platen.
3. Firmly press the base with the sanding sheet attached against a
flat surface and briefly switch the tool on. This provides for good
adhesion between the platen and the sanding sheet and also
helps to prevent premature wear.
4. When the tip of the sanding sheet becomes worn, detach the
sheet from the platen, rotate and reapply.
ATTACHING ACCESSORIES USING THE UNIVERSAL
ADAPTER (FIG. 6)
Non-D WALT accessories can be
E
attached using the universal adaptor.
1. Place the washer (K) on the tool.
2. Place accessory on to washer.
3. Tighten and secure adaptor nut (L)
using a hex wrench.
CAUTION: To avoid injury, do not use any accessory for an
FIG. 5
application where the adaptor may fail to hold the accessory.
CAUTION: Read and follow all manufacturers' safety warnings for
J
any accessories used with this tool.
CAUTION: To avoid injury, ensure adaptor and accessory are
securely tightened.
Attaching the Cut Guide (Fig. 7–11)
The depth/cut guide allows you to precisely
cut material at a specified depth and more
accurately track a marked cut line.
1. Attach the cut guide block (F) by
I
2. Secure the block to the main body with
DEPTH GUIDE
This feature allows you to precisely cut
material at a specified depth.
1. Insert the guide arm (G) as shown in
FIG. 6
2. Adjust the length of the guide by pulling out or pushing inward to
3. Secure the guide in place by turning the depth/cut adjustment
L
K
6
inserting the tabs (M) on the guide into
the accessory side mount (E) on the
main body of the tool.
the supplied screw (O) and tighten with
the supplied hex wrench (P).
Figure 8 into the front slot on the guide
block (F).
achieve the desired cut depth as shown in Figure 9.
knob clockwise. To release the guide, turn the depth/cut
adjustment knob counterclockwise.
FIG. 7
E
M
F
O
P