Grounding Instructions - Makita 9237C Manual De Instrucciones

are connected and properly used. Use of dust
collection can reduce dust-related hazards.
Power tool use and care
17. Do not force the power tool. Use the correct
power tool for your application. The correct
power tool will do the job better and safer at the
rate for which it was designed.
18. Do not use the power tool if the switch does not turn
it on and off. Any power tool that cannot be controlled
with the switch is dangerous and must be repaired.
19. Disconnect the plug from the power source
and/or the battery pack from the power tool
before making any adjustments, changing
accessories, or storing power tools. Such
preventive safety measures reduce the risk of
starting the power tool accidentally.
20. Store idle power tools out of the reach of
children and do not allow persons unfamiliar
with the power tool or these instructions to
operate the power tool. Power tools are
dangerous in the hands of untrained users.
21. Maintain power tools. Check for misalignment
or binding of moving parts, breakage of parts
and any other condition that may affect the
power tool's operation. If damaged, have the
power tool repaired before use. Many accidents
are caused by poorly maintained power tools.
22. Keep cutting tools sharp and clean. Properly
maintained cutting tools with sharp cutting edges
Ampere Rating
More Than
0
6
10
12
000173

GROUNDING INSTRUCTIONS:

This tool should be grounded while in use to protect
the operator from electric shock. The tool is
equipped with a three-conductor cord and three-
prong grounding type plug to fit the proper
grounding type receptacle. The green (or green and
yellow) conductor in the cord is the grounding wire.
Never connect the green (or green and yellow) wire
to a live terminal. Your unit is for use on 120 volts
and has a plug that looks like Fig. "A".
Table 1: Minimum gage for cord
Not More Than
6
10
12
16
are less likely to bind and are easier to control.
23. Use the power tool, accessories and tool bits
etc. in accordance with these instructions,
taking into account the working conditions
and the work to be performed. Use of the
power tool for operations different from those
intended could result in a hazardous situation.
Service
24. Have your power tool serviced by a qualified
repair
replacement parts. This will ensure that the
safety of the power tool is maintained.
25. Follow
changing accessories.
26. Keep handles dry, clean and free from oil and
grease.
USE PROPER EXTENSION CORD. Use only three-
wire extension cords that have three-prong grounding-
type plugs and three-pole receptacles that accept the
tool's plug. Make sure your extension cord is in good
condition. Replace or repair damaged or worn cord
immediately. When using an extension cord, be sure to
use one heavy enough to carry the current your product
will draw. An undersized cord will cause a drop in line
voltage resulting in loss of power and overheating.
Table 1 shows the correct size to use depending on
cord length and nameplate ampere rating. If in doubt,
use the next heavier gage. The smaller the gage number,
the heavier the cord.
Volts Total length of cord in feet
120 V 25 ft.
18
18
16
14
Fig. A
Grounding
Blade
000088
3
person using only
instruction for lubricating
50 ft. 100 ft.
AWG
16 16
16 14
16 14
12 Not Recommended
Cover of Grounded
Outlet Box
identical
and
150 ft.
14
12
12