Using The Timer - Qlima SRE 3130 C Instrucciones De Uso

G

USING THE TIMER

The timer allows you to activate the heater at a certain time. In order to use the timer,
the correct actual time must have been set (refer to section C).
To set the timer:
Press the button and the word TIMER will appear on the display. Use the buttons
p
and to set the time at which the heater has to start. Press the
press the TIMER button within 1 sec. The TIMER lamp switches on and the heater is
ready to start at the desired time.
H
SWITCHING OFF THE HEATER
Press the button. The red lamp inside the
stops within approximately 1 minute. A little white smoke and smell during the
extinguish period is normal.
I
SAVE MODE
In the save mode the heater will switch off when the room temperature, as sensed by
the heater, rises 3°C above the set temperature. The save mode can be activated with
the button SAVE. The lamp in the button will switch on and the heater will now switch
off when the room temperature rises 3°C above the set temperature. The heater will
start again when the room temperature drops below the set temperature.
The save mode can be cancelled by pushing the SAVE button again, the lamp switches
off.
J
THE INFORMATION DISPLAY
The information display not only serves as an indicator of the (set) time and
temperature, it also indicates any malfunctioning of the heater. The code on the
information display tells you what is the matter:
CODE CAUSES
e - 0
No flame during ignition.
e - 1
Flame sensor failure
e - 2 No flame after ignition.
button first, then
button will switch off and the heater
WHAT TO DO
Check fuel, restart the heater.
Read section R point 5.
Use correct fuel (see section "The
right fuel").
Check fuel, restart the heater.
Read section R point 5.
Use correct fuel (see section "The
right fuel").
Check fuel, restart the heater.
Read section R point 5.
Use correct fuel (see section "The
right fuel").
4
q
32