Qlima SRE 3130 C Instrucciones De Uso página 35

e - 4
e - 5
e - 6
e - 7
e - 9
e - a
e - h
e 1 1
f 0
-- . --
Always contact your dealer for any malfunctioning not listed above and/or when the
error keeps occuring after taking the corrective measure as described above.
K
AUTOMATIC DEACTIVATION
This heater is equipped with a safety system that ensures that it switches off
automatically after 48 hours of continuous operation. The display will show:
Switch on the heater by pressing the
L
KEY LOCK
The key lock can be used to prevent children accidentally starting the heater. Press the
button
All keys are blocked now, the heater will not respond to any pressing of the buttons.
Press the button
memorized and remains after a power interrupt. Press the
the blue light of the background without changing other parameters
4
33
Abnormal burning or irregular flame. Check fuel, ventilate the room,
Ignition temperature too low.
Ignition temperature too high.
the mains plug and restart.
Wrong blower speed.
Tilt switch.
be levelled.
Room temperature > 35°C
the heater.
Electronics temperature > 60°C
the heater.
KEY LOCK.
Out of fuel. + red light
The heater shows the actual time
The heater shows the set time for
timer
The heater has been operating
continuously for a period of 48
hours and has switched itself off
(refer to section K).
Too little ventilation
5 sec display
Overheating during operation or power failure during shutdown
3 times when the heater is off. The characters KL will appear in the display.
again 3 times to release the key lock. The status of the
restart the heater. Read section R
point 5. Use correct fuel (see sec-
tion "The right fuel").
Disconnected the mains plug and
restart.
Cool down, disconnect
Disconnect the mains
restart.
Avoid shocks. The heater must
Ventilate the room and restart
Ventilate the room and restart
Push the button KEY LOCK 3
times to unlock the heater.
flashes Refill the removable tank. Check
if the fuel filter contains water.
Push the – and + buttons to
adjust the time.
Push the – and + buttons to
adjust the set time when the
heater has to start.
Switch the heater on again.
Ventilate better
Auto-restart, see chapter D
button.
button once to activate
plug and
.
is