Ec Declaration Of Conformity; Walther Spritz- Und Lackiersysteme Gmbh Kärntner Str; D- 42327 Wuppertal; 11 815 - Walther PILOT BOND 2K Manual De Servicio

Table of contents
Explosion drawing
Declaration of conformity
Listing of Replacement Parts
1 General
1.1 Model identification
1.2 Intended use
1.3 Unintended use
2 Technical description
3 Safety instructions
3.1 Identification of safety instructions
3.2 General safety instructions
4 Connecting supply lines and Operation
4.1 Generating a spray pattern test
4.2 Changing the spray pattern
5 Converting / repairing the spray gun
5.1 Changing the material nozzle and air cap
5.2 Replacing the material needle (component A)
5.3 Replacing the Valve component B
5.4 Replacing a leaking needle packing (component A)
5.5 Correcting flaws of spray pattern
6 Cleaning
7 Troubleshooting and fault correction
8 Disposal
9 Technical data
2
21
22
24
24
24
24
25
25
25
25
26
27
27
27
28
28
29
29
30
30
32
32
33
20

EC Declaration of conformity

We, the device manufacturer, declare at our sole responsibility that the product with the
description below corresponds to the relevant based safety and health requirements. In
the event of changes to the device not agreed on with us or if used improperly this
declaration becomes invalid.
Manufacturer Walther Spritz- und Lackiersysteme GmbH
Kärntner Str. 1830
D - 42327 Wuppertal
Phone: +49(0)202 / 787 - 0
Fax: +49(0)202 / 787 - 2217
www.walther-pilot.de • email: info@walther-pilot.de
Type designation
Two-component hand spray gun
PILOT BOND 2K
Wide jet
Round jet
Purpose of use Processing of sprayable materials
Applied standards and directives
EC Machinery Directive 2006 / 42 / EC
EN ISO 12100 Part 1
EN ISO 12100 Part 2
DIN EN 1127-1
Specifications according to Directive 94 / 9 / EC
Authorized to compile the technical documentation:
Nico Kowalski, WALTHER Spritz- und Lackiersysteme GmbH, Kärntner Str. 18 - 30

D- 42327 Wuppertal

Special notes:
The product is intended to be installed in another device. Commissioning is prohibited
until conformity of the end product with Directive 2006 / 42 / EC has been verified.
Wuppertal, 11 February 2016
ppa.
Name: Torsten Bröker
Position in the company: Head of Design and Development
This declaration does not represent a promise of properties according to product liability. The safety instructions
of the product documentation must be observed.
V 11 815
V 11 816
21