DeWalt DW45RN Manual De Instrucciones página 9

3. To install a 3/8" (9.5 mm) fitting: screw the fitting into the 3/8"
(9.5 mm) adapter and then into the air inlet of the tool and tighten
firmly.
OPERATION
Preparing the Tool
WARNING: Read the section titled Important Safety Instructions
at the beginning of this manual. Always wear eye and ear protection
when operating this tool. Keep the nailer pointed away from yourself
and others. For safe operation, complete the following procedures
and checks before each use of the nailer.
NOTICE: To reduce the risk of damage to the tool, only use D
pneumatic tool oil or a non-detergent SAE 20 weight oil. Oil with
additives or detergent will damage tool parts.
1. Before you use the nailer, be sure that the compressor tanks
have been properly drained.
2. Lubricate the tool following these directions:
a. Use D WALT pneumatic tool oil or a non-detergent S.A.E. 20
e
weight oil. DO NOT use detergent oil or additives as they will
damage o-rings and rubber parts.
b. Use a filter-regulator-lubricator in the air line between the
compressor and the tool when possible.
c. If a lubricator is not available, add 5 to 7 drops of oil in the air
fitting a least twice a day or every 4 hours of use.
3. Wear proper eye, hearing and respiratory protection.
4. Ensure canister is empty of all fasteners.
5. Check for smooth and proper operation of contact trip and
pusher assemblies. Do not use tool if either assembly is not
functioning properly. NEVER use a tool that has the contact trip
restrained in the up position.
6. Check air supply. Ensure that air pressure does not exceed
recommended operating limits, refer to Tool Specifications.
7. Keep tool pointed away from yourself and others.
8. Connect air hose.
9. Check for audible leaks around valves and gaskets. Never use a
tool that leaks or has damaged parts.
WARNING: To reduce the risk of personal injury, disconnect tool
from air supply before performing maintenance, clearing a jammed
fastener, leaving work area, moving tool to another location or
handing the tool to another person.
Loading the Tool (Fig. 2–4)
WALT
e
WARNING: Keep the tool pointed away from yourself and others.
Serious personal injury may result.
WARNING: Never load nails with the contact trip or trigger
activated. Personal injury may result.
1. Read all Safety Warnings before using tool.
2. Connect the air supply to the tool.
3. Push the door latch
(D) to open the nail
guide door (G).
4. Rotate the canister
cover (C) open.
5. Adjust the
platform (I) to properly
accommodate the nail
length being used.
• Push the platform
lever (J).
7
FIG. 2
D
nail
G
C