Blackout-Socket; Dmx-512 Connection / Connection Between Fixtures; Connection With The Mains - Futurelight DJ-SCAN 575 Manual Del Usuario

Blackout-socket

If you wish to lock the light output - e.g. via an optional footswitch (Blackout-mode) or an Easy-2 remote
control, connect your footswitch or Easy-2 remote control via a mono-jack plug to the Blackout-socket.

DMX-512 connection / connection between fixtures

The wires must not come into contact with each other, otherwise
Only use a stereo shielded cable and 3-pin XLR-plugs and connectors in order to connect the controller with
the fixture or one fixture with another.
Occupation of the XLR-connection:
If you are using controllers with this occupation, you can connect the DMX-output of the controller directly
with the DMX-input of the first fixture in the DMX-chain. If you wish to connect DMX-controllers with other
XLR-outputs, you need to use adapter-cables.
Building a serial DMX-chain:
Connect the DMX-output of the first fixture in the DMX-chain with the DMX-input of the next fixture. Always
connect one output with the input of the next fixture until all fixtures are connected.
Caution: At the last fixture, the DMX-cable has to be terminated with a terminator. Solder a 120
between Signal (–) and Signal (+) into a 3-pin XLR-plug and plug it in the DMX-output of the last fixture.

Connection with the mains

Connect the device to the mains with the enclosed power supply cable.
The occupation of the connection-cables is as follows:
Cable Pin
Brown Live
Blue Neutral
Yellow/Green Earth
The earth has to be connected!
Occupation mono 1/4" jack-plug:
Tip
In Phase (+)
the fixtures will not work at all, or will not work properly.
International
L
N
Sleeve
Ground
29/64
Ω
resistor
DJ_SCAN_575_V_1_0