Assembly & Set-Up; Tractor Set-Up; California Proposition 65 Warning - MTD 760 Serie Manual De Operador

EVANS.COM.MX PROPIEDAD EVANS.COM.MX PROPIEDAD EVANS.
Assembly & Set-Up
PROPIEDAD EVANS.COM.MX PROPIEDAD EVANS.COM.MX PROPIE
EVANS.COM.MX PROPIEDAD EVANS.COM.MX PROPIEDAD EVANS.

Tractor Set-Up

NOTE: This Operators Manual covers a range of product
PROPIEDAD EVANS.COM.MX PROPIEDAD EVANS.COM.MX PROPIE
specifications for various models. Characteristics and features
discussed and/or illustrated in this manual may not be applicable
to all models. MTD reserves the right to change product
specifications, designs and equipment without notice and
EVANS.COM.MX PROPIEDAD EVANS.COM.MX PROPIEDAD EVANS.
without incurring obligation.
Connecting the Battery Cables
PROPIEDAD EVANS.COM.MX PROPIEDAD EVANS.COM.MX PROPIE

CALIFORNIA PROPOSITION 65 WARNING

Battery posts, terminals, and related accessories
contain lead and lead compounds, chemicals known
EVANS.COM.MX PROPIEDAD EVANS.COM.MX PROPIEDAD EVANS.
to the State of California to cause cancer and
reproductive harm. Wash hands after handling.
CAUTION:
PROPIEDAD EVANS.COM.MX PROPIEDAD EVANS.COM.MX PROPIE
connect the POSITIVE (Red) wire to its terminal first,
followed by the NEGATIVE (Black) wire.
EVANS.COM.MX PROPIEDAD EVANS.COM.MX PROPIEDAD EVANS.
For shipping reasons, both battery cables on your equipment
may have been left disconnected from the terminals at the
factory. To connect the battery cables, proceed as follows:
PROPIEDAD EVANS.COM.MX PROPIEDAD EVANS.COM.MX PROPIE
NOTE: The positive battery terminal is marked Pos. (+). The
negative battery terminal is marked Neg. (–).
1. Remove the plastic cover, if present, from the positive
EVANS.COM.MX PROPIEDAD EVANS.COM.MX PROPIEDAD EVANS.
battery terminal and attach the red cable to the positive
battery terminal (+) with the bolt and hex nut. See Figure
3-1.
PROPIEDAD EVANS.COM.MX PROPIEDAD EVANS.COM.MX PROPIE
EVANS.COM.MX PROPIEDAD EVANS.COM.MX PROPIEDAD EVANS.
PROPIEDAD EVANS.COM.MX PROPIEDAD EVANS.COM.MX PROPIE
EVANS.COM.MX PROPIEDAD EVANS.COM.MX PROPIEDAD EVANS.
PROPIEDAD EVANS.COM.MX PROPIEDAD EVANS.COM.MX PROPIE
EVANS.COM.MX PROPIEDAD EVANS.COM.MX PROPIEDAD EVANS.
PROPIEDAD EVANS.COM.MX PROPIEDAD EVANS.COM.MX PROPIE
2. Remove the plastic cover, if present, from the negative
battery terminal and attach the black cable to the negative
battery terminal (–) with the bolt and hex nut. See Figure
EVANS.COM.MX PROPIEDAD EVANS.COM.MX PROPIEDAD EVANS.
3-1.
PROPIEDAD EVANS.COM.MX PROPIEDAD EVANS.COM.MX PROPIE
When attaching battery cables, always
Figure 3-1
3. Position the red rubber boot over the positive battery
terminal to help protect it from corrosion.
NOTE: If the battery is put into service after the date shown
on top/side of battery, charge the battery as instructed in the
Maintenance section your Operator's Manual prior to operating
the tractor.
Shipping Brace Removal
WARNING!
off, remove the ignition key, and set the parking
:
brake before removing the shipping brace. Refer to
the Controls and Features section for instructions on
how to set the parking brake.
1. For tractors with a 38" deck continue with step a below, for
tractors with 42", 46", 50" & 54" decks skip ahead to Step 2.
a. Locate the shipping brace, if present, and
accompanying warning tag found on the right side
of the mower, between the discharge chute and the
cutting deck. See Figure 3-2.
b. Place the deck lift lever in the highest cutting
position. Refer to Setting the Cutting Height in the
Operation section of this manual.
c. While pushing the discharge chute towards the
machine with your left hand, remove the shipping
brace with your right hand by grasping it between
your thumb and index finger and rotating it
clockwise.
Make sure the riding mower's engine is
Figure 3-2
3
9