Names Of Parts And Their Functions; Front Panel; Front Panel (Open View) - Ikegami INR-Q500 Manual De Instrucciones

3. Names of parts and their functions

3-1. Front panel

① POWER LED (green)
Stays on while the power is on.
② HDD LED (green)
Stays on while the hard disk drive is accessed.
③ REC LED (red)
Stays on while recording is going on.
④ ETHERNET LED (green)
Lights up when data has been received from a camera in question.
⑤ ERROR LED (yellow)
Lights up if the hard disk drive gets in trouble.

3-2. Front panel (open view)

① Power button
Make sure the main power switch on the rear panel is at the "I" (ON) position. Press this
button, and the recorder gets started in 1 minute or so. When this button is pressed again, the
recorder does the end processing and turns off in 20 minutes or so.
* Just press on the power button to shut down the recorder in usual way. If the button
is held down longer than 4 seconds, the power is forced off without the end process-
ing. But this is for shutting down the unit in case of emergency. Never hold down the
button under normal conditions.
② Reset button
Press this button to get the recorder restarted. It takes about 90 seconds to reboot the unit.
③ DVD-RAM drive
Insert an FAT32-formatted DVD-RAM disk, which is writable faster than 5 times, to back up
the alarm records.
Recommended DVD-RAM disk
Hitachi Maxell
Mitsubishi Kagaku Media
① ② ③ ④ ⑤
DRM47C.1P (1 disk), DRM47C.1P5S (5 disks)
DHM47GN1 (1 disk), DHM47GN5 (5 disks)
E-2
③
② ①