Commissioning; Settings; Connecting Electric Power Tools; Connecting Pneumatic Tools - Festool CTL 48 E LE EC/B22 R1 Manual De Instrucciones

CT B22
GB
CTL 48 E LE EC/B22 R1: The mobile dust extractor
is designed for extracting hazardous dust with limit
values up to 1 mg/m³ from dust class 'L' in accor-
dance with IEC 60335-2-69.
The mobile dust extractor is designed to extract
water
as well as for heavy-duty applications and industri-
al use in accordance with IEC 60335-1 and IEC
60335-2-69.
The mobile dust extractor is not suitable for ex-
tracting dust that poses a high risk of explosion
(e.g. explosives), flammable dust with an ignition
energy of less than 1 mJ (labour authorities), flam-
mable liquids and mixtures of combustible dust and
flammable liquids.
The mobile dust extractor is not suitable for equip-
ment that generates sources of ignition.
The user is liable for improper or non-in-
tended use.
6

Commissioning

WARNING
Unauthorised voltage or frequency!
Risk of accident

The mains voltage and the frequency of the pow-
er source must correspond with the specifica-
tions on the machine's name plate.

In North America, only Festool machines with
the voltage specifications 120 V/60 Hz may be
used.
6.1 Initial operation

Open the locking clips [2-2] and remove the top
section of the machine [2-1].

Remove the accessories from the dust contain-
er [2-3] and the packaging!

Insert a filter bag in the dust container that ful-
fils statutory requirements (see chapter 7.8).

Replace the top section [2-1] and close the
locking clips [2-2].

Attach the cable holder to the rear of the mobile
dust extractor (see Fig. [3]).

Insert the sealing plug [1-1] on the panel (see
Fig. [1] ).

Connect suction hose at the extractor opening
[1-2].
6.2

Switch on/off


Insert the plug into an earthed socket.
The use of extension cables in Zone 22 is not
permitted.
18
CAUTION
Risk of injury from tools starting up unexpectedly

Before setting the switch to the "AUTO" or
"MAN" position, make sure that the connected
tool is switched off.
The switch [1-9] serves as an on/off switch.
Switch position "0"
Appliance socket [1-11] is disconnected from the
power, mobile dust extractor is switched off.
"MAN" switch position
Appliance socket [1-11] is connected to the power,
the mobile dust extractor starts.
"Auto" switch position
Appliance socket [1-11] is connected to the power,
the mobile dust extractor starts when the connect-
ed tool is switched on.
7

Settings

7.1 Adjusting the hose diameter

Adjust the hose diameter adjuster [1-8] to
match the diameter of the connected hose.
 The monitoring devices will measure the air
speed in the extractor hose correctly as a result
(see chapter 7.9).
7.2

Connecting electric power tools

WARNING
Risk of explosion, risk of injury

Do not use the appliance's socket in zone 22.

Observe the maximum appliance socket con-
nected load (see chapter "Technical data")

Switch off the electric power tool.

Connect the electric power tool to the appliance
socket [1-11].
7.3

Connecting pneumatic tools

WARNING
Risk of injury

Switch off the air tool.
With the compressed air module [1-3], the auto-
matic switch-on function for the mobile dust ex-
tractor also works in conjunction with air tools.