First Switch On - Mec PM05016 Instrucciones De Montaje Y De Uso

First switch on

Once the power supply has been connected, check that the green led on the connector side of
the control unit remains lit for more than 5 seconds.
If it remains lit: correct installation.
If it does not light up: no mains power supply and the batteries are flat or missing, check power
supply unit and battery connections.
If it flashes with a short flash and a long pause: battery operated, check power supply unit
connection.
If it flashes with a long flash and a short pause: batteries are being recharged, wait for 36
hours and replace batteries if flashing continues.
note: The batteries (5) are only to be used in the event of a power failure; always use
rechargeable AA NIMH 2000mAh minimum batteries.
technical Data
Electrical
Power supply
Control unit
Humidity range (for power supply only)
Room temperature
IP protection rating
Backup batteries (5)
►battery life
Electrical consumption
Operating mode
Tap off
Tap on
Flow rate control or mixing mode (peak)
Wall-Plug - 100-240 Vac ; 50-60 hz
9VDc= 1a
10-90%
0-40°c
IPX5 (control unit) IPX0 (Power supply)
nIMh tipo aa 1.2V - 2000mah (min.)
► 120 h with tap on stand-by
► 15 h of operation with tap on
(ma)
10
20
1200
23
EnglIsh
(W) @ 9VDc
0.09
0.18
10.8