Use And Installation Instructions; Sun Shield; Inner Lining; Snap-Fastener System - Crivit 278612 Instrucciones De Uso

Pinlock 30
®
The plastic lens in the Pinlock
visor absorbs moisture . The air
pocket between the lens and visor reduce the
difference between the temperature inside the
helmet and the outdoor temperature .
Integrated sun shield
High-strength
HCM outer shell
High Density Copolymer Matrix:
High quality ABS plastic is
formed under extreme heat and
pressure to make a robust and
impact-resistant outer shell .
Anti-scratch coated
visor
Separate winter
comfort collar
Removable,
washable liner
Toolless visor changes
With an additional set
of cheek pads for a
custom fit
Suitable for
eyeglass wearers
Safety lock closure
Use and Installation
Instructions
®
Sun Shield (Fig. C)
The integrated sun shield (10) will enable you to
quickly and easily react to changed light condi-
tions with the aid of the patent mechanism .
To pull out and retract the sun shield, press the
safety latch to operate the slider (5) .
Note:
• Please take care that the edge of the sun shield
does not block your field of vision .
• The sun shield may only be used when the visor
is closed and may only be used during the day .
Inner Lining (Fig. D)
The inner lining (15) can be completely removed
and cleaned separately (see care instructions) .
To remove the inner lining, firstly remove the
helmet collar and the cheek pads . Then undo the
back press-studs of the inner lining and pull the
clips of the inner lining from the front side of the
helmet .
Snap-Fastener System (Fig. E)
The snap-fastener enables an individual and
quick vernier adjustment of the chin strap .
Press the snap-fastener together until the helmet is
sitting comfortably but firm .
The movable buckle may be used to fasten or
secure excess chin strap .
Chin-Wind Deflector (Fig. F)
The chin-wind deflector (12) is secured to the
pivoted piece by means of snaps .
This can be removed and re-attached as
required .
Cheek Pads (Fig. G)
You will receive two different pairs of cheek
pads (14) for individual size adjustment .
The thinner cheek-pads are already pre-mounted
as standard . The thicker cheek pad is enclosed
with the helmet separately .
If the helmet is too loose and therefore is not sit-
ting firmly on your head, you can replace the thin
cheek pad with the thicker ones .
GB/IE 17