Setting up Captur Module - Pro
The Captur Module - Pro is used as an accessory with the Captur (sold
separately) to control the camera wirelessly. The Captur and the Captur
Module - Pro must be channel matched using DCM. Alternatively you
can also connect the Captur Module - Pro directly to a DSLR camera with a
camera cable (sold separately).
Digital Channel Matching – DCM (Requires Captur Transmitter)
a. Transmitter - Press and hold button + Turn 'ON'. LED will flash green
rapidly
b. Timer - Press and hold SET button
red
c. Receiver - Press and hold button + Turn 'ON'. LED will show steady red
d. DCM is complete. Turn both Module - Pro, Receiver and Transmitter 'OFF'
and 'ON' to reboot
Note: For multiple Receivers repeat step 'c' for all receivers without
turning off transmitter
Manual Remote Control
Release Button
The
push = Autofocus, LED
25
LED
shows red. To 'HOLD' the shutter release for bulb photography,
Release Button
press down
flash red. Press
Interval Timer Programmable Functions
Ensure that LCD is displaying
Start/Stop
Module - Pro will now take a photo continuously at the factory set interval
Start/Stop
time. Press
Press SET button
- is used to adjust the value of the parameters. Press SET button
confirm adjustment. The values of the following parameters can be adjusted
as required. Use
parameters which need to be adjusted.
6
works similarly to the camera shutter release. ½
25
shows steady green. Full push = Shutter release,
Release Button
3
button to 'Start' the 'Interval Timed Photography'. The Captur
again to 'Stop' the interval timed photography.
27
to adjusted parameters.
Toggle Button
27
+ Turn 'ON'. LED will show steady
for more than 3 seconds and LED
again to release the hold.
4
5
6
,
,
,
or
Toggle Button
28
< or > to move between the
25
7
. Press
28
27
again to
Captur Module - Pro
will
+ or