Installation Procedure - Toto Renesse TL170DD Manual De Instrucciones Y Del Propietario

IMPORTANT! Before installation, any dirt and debris in the cold/hot water supply pipes must be washed out.
1) Wipe off any dirt around the installation
hole.
2) Measure the installation hole, then select a
gasket that matches the hole diameter from
the 2 kinds provided.
Hole over ø Hole under ø
1-7/16" (36mm) 1-7/16" (36mm)
Winged Gasket Flat Gasket
N OTE: If the wrong gasket is used, water
may leak under the counter.
3) Place the gasket around both the connection pipe and mounting shaft,
and move it up against the bottom surface of the faucet body. Place it
into the mounting hole until the spout rests on the surface.
C AUTION: Be careful not to scratch or contaminate the o-ring. Other-
wise, water leakage may occur.
4) Place the mounting flange onto the shaft of the faucet as shown to the
right. Place the flat washer and lock washer onto the shaft and fasten
the nut until snug. Double-check faucet alignment and tighten nut to
secure.
5) Press shank body onto connection pipe until it is fully seated. Place flat
washer and lock washer onto bottom of connection pipe and fasten nut
tightly to secure.
1) Wipe off any dirt around the installation hole.
2) Place the deck sealing gasket (white) around
both hoses of one valve assembly and move it
to the top, stopping just below the cartridge
and nut. Place hoses through the mount-
ing hole and allow the valve to rest on the
surface.
C AUTION: The valve body assembly (la-
beled C) of the cold water supply must be
installed on the right side of the spout, the
valve body assembly (labeled H) of the hot
water supply must be installed on the left
side.
3) From below the mounting surface, place gas-
ket (black) around both hoses followed by slip
washer and fastening nut. Thread nut onto
valve body until valve unit is secure.
4) Repeat step 3 for the other valve assembly.
C AUTION: When placing the connecting
hose through the fastening nut, make the
cap nut go through the escape hole.

INSTALLATION PROCEDURE

Installing the Spout
Spout
Spout Mounting
Spout Bottom
Connection Pipe
Gasket
Installation Hole
Installing the Valve Assemblies
5
Shaft
Flat Washer (small)
Lock Washer (small)
Mounting Nut
Cold Water Supply
Valve Body Assembly
Gasket (white)
Counter
Gasket (black)
Slip Washer
Top
Cold Water
Relief hole for
Supply Hose
hose passage
Bottom
Spout
Spout
Mounting
Shaft
Spout
Mounting
Flange
Flat
Washer (big)
Lock
Washer
(big)
Spout
Mounting
Mounting
Shaft
Nut
Spout
Shank Body
Spout
Fastening
Nut
Connecting
Hose
Cap Nut
C Label