Maintenance; Warranty - SPARKY HAG 1600 Instrucciones De Uso

WARNING: Glass is a fragile material and can
break easily.
WARNING: Do not strip metal window frames,
as the heat may be conducted onto the glass and
crack it.
Defrosting water pipes (Fig. 5)
Choose the reflector nozzle (9).
Always heat the pipe from the end of the frozen portion
towards the middle.
Warm plastic pipes as well as connections between pipe
pieces especially carefully to prevent damage.
WARNING: Water lines often do not differ in
appearance from gas lines. Gas lines are not to be
heated under any circumstances - danger of explo-
sion.
Welding plastic tubes (Fig. 6)
Choose the reduction (7) or reflector (9) nozzle.
The materials being welded together must be of exactly
the same type of plastic.
The areas being welded must be clean and grease-free.
Heat one of the tubes in the joint until the material be-
comes tacky, and then apply the other tube.
Please note that plastics can very quickly change from
being tacky into becoming liquid.
Shrink fitting (Fig. 7)
Choose the reflector (9) or reduction (7) nozzle.
Select a heat-shrinkable tube with diameter, appropriate
for the workpiece (for example, a cable lug).
Heat the heat-shrinkable sleeve evenly.
Bending plastic tubes (Fig. 8)
Choose the reflector nozzle (9).
Set the tool down on its rear in an upright position with
the nozzle pointing upwards.
To avoid buckling or kinking the tube, fill the tube with dry
sand and seal at both ends.
Heat the tube evenly by moving from side to side and
bend to required shape.

Maintenance

WARNING: Always ensure that the tool is
switched off and unplugged before attempting to per-
form inspection or maintenance.
Regularly inspect all fasteners and ensure they are prop-
erly tightened.
CLEANING
For safe operation always keep the machine and its ven-
tilation slots clean.
Original instructions
Regularly check to see if any dust or foreign matter has
entered the grills near the motor and around the switch.
Use a soft brush to remove any accumulated dust. Wear
safety glasses to protect your eyes whilst cleaning.
If the body of the tool needs cleaning, wipe it with a soft
damp cloth. A mild detergent can be used.
WARNING: Never use alcohol, petrol or other
cleaning agent. Never use caustic agents to clean
plastic parts.
WARNING: Water must never come into con-
tact with the tool.
IMPORTANT! To assure product safety and reliability,
repairs, maintenance and adjustment should be per-
formed by certified service centres or other qualified
service organisations, always using genuine replace-
ment parts.

Warranty

The guarantee period for SPARKY power tools is deter-
mined in the guarantee card.
Faults due to normal wear, overloading or improper han-
dling will be excluded from the guarantee.
Faults due to defective materials implemented as well as
defects in workmanship will be corrected free of charge
through replacement or repair.
The complaints for defective SPARKY power tools will
be recognized if the machine is sent back to the dealer
or is presented to the authorised warranty service centre
undismantled, in its initial condition.
Notes
Carefully read the entire original instructions before us-
ing this product.
The manufacturer reserves the right to make changes
and improvements to the products and to alter specifica-
tions without prior notice.
Specifications may differ from country to country.
7
EN