Functional Description - SSP MUB103 Manual De Instrucciones

BLOWER SAFETY WARNINGS
1. Always use protective goggles, a cap and
mask when using the blower.
2. Never point the nozzle at anyone in the
vicinity when using the blower.
3. Warning - Electric shock could occur if used
on wet surfaces. Do not expose to rain. Store
indoors.
4. Never block suction inlet and/or blower outlet.
Increased motor
dangerous fan breakage.
5. The blower is not intended for use by young
children or
supervision.
6. Young children should be supervised to
ensure that they do not play with the blower.
SAVE THESE INSTRUCTIONS.
WARNING:
DO NOT let comfort or familiarity with product
(gained from repeated use) replace strict adherence
to safety rules for the subject product. MISUSE or
failure to follow the safety rules stated in this
instruction manual may cause serious personal
injury.
Symbols
The followings show the symbols used for tool.
･
volts
･
amperes
･
hertz
･
alternating current
･
no load speed
･
Class II Construction
･
revolutions or reciprocation per minute
revolution may
infirm persons
GEB073-1

FUNCTIONAL DESCRIPTION

CAUTION:
Always be sure that the tool is switched off and
•
unplugged before adjusting or checking function
on the tool.
Switch action
CAUTION:
Before plugging in the tool, always check to see
•
cause
that the switch trigger actuates properly and
returns to the "OFF" position when released.
without
1
013219
To start the tool, simply pull the switch trigger. Release
the switch trigger to stop.
For continuous operation, pull the switch trigger and
then push in the lock button, and then release the
switch trigger.
USD201-2
To stop the tool from the locked position, pull the switch
trigger fully, then release it.
Air volume adjusting dial
013220
Air speed and volume can be adjusted without positive
stops by turning the air volume adjusting dial
To obtain high speed and increase volume, turn the air
volume adjusting dial to the A direction shown in the
figure (for the bigger number). Turn the air volume
adjusting dial to the B direction (for the smaller number)
to obtain low speed and to decrease the air volume
ASSEMBLY
CAUTION:
Always be sure that the tool is switched off and
•
unplugged before carrying out any work on the tool.
4
1. Switch trigger
2
2. Lock button
1. Air volume
adjusting dial
B
A
1