Troubleshooting - HIKOKI WR 36DA Instrucciones De Manejo

TROUBLESHOOTING

Use the inspections in the table below if the tool does not operate normally. If this does not remedy the problem, consult your
dealer or the HiKOKI Authorized Service Center.
1. Power tool
Symptom
Tool doesn't run
Tool suddenly stopped
Tool sockets
-can't be attached
-fall off
-can't be removed
Switch can't be pulled
An abnormal high-pitched
noise occurs when the
trigger switch is pulled.
Battery cannot be installed
Possible cause
No remaining battery power
Tool was overburdened
The battery is overheated.
The trigger switch was held down for
5 minutes or more.
The shape of the attachment portion doesn't
match
Forward/reverse selector button is
positioned halfway
The trigger switch is being pulled only
slightly.
Attempting to install a battery other than that
specifi ed for the tool.
Charge the battery.
Get rid of the problem causing the
overburden.
Let the battery cool down.
This is not a malfunction.
The motor was automatically stopped to
prevent failure of the tool.
Make sure to use sockets with the
appropriate square drive size.
WR36DA: 19 mm
WR36DB: 12.7 mm
Press the button fi rmly into position for the
desired direction of rotation.
This is not a malfunction.
It does not occur if the trigger switch is
pulled more fully.
Please install a multi volt type battery.
15
English
Remedy