ECG R 222 Manual De Instrucciones página 15

Radio portátil
Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 32
Replace batteries only with batteries of the same type and with correct polarity. Otherwise there is a risk
the system may explode.
In the following cases, unplug the device and contact a qualified service:
The power cord was damaged
The device was infiltrated by a foreign object or liquid, or it was exposed to rain or water.
The appliance does not operate normally in accordance with the manual. Set only the elements
described in the operating manual.
The device has significant functionality changes, indicating a need for service.
Do not expose the device to heat sources such as radiators, heating or other heat-producing appliances
such as amplifiers.
Changes or modifications not expressly approved by the responsible authority can lead to loss of
authorization to use the device.
Excessive sound pressure from earphones can cause hearing damage.
OPERATION
Turning the device on
Set the device on a flat, stable surface, with controls easily accessible.
Ensure adequate ventilation of the device.
Power (mains):
Connect the supplied power cord (can be stored in the battery compartment) to the AC ~ jack on the rear
panel and the other end of the cord insert into an electrical outlet that is properly installed.
Make sure that the voltage corresponds to the voltage on the nameplate.
Power (batteries):
(not included)
Open the cover of the battery compartment and insert 4 batteries R14 1,5V. Observe the correct battery
polarity as indicated on the bottom of the battery compartment.
Close the cover of the battery compartment.
If the device is not used for long periods, remove the batteries to prevent battery leakage.
CAUTION
Do not expose batteries to excessive heat, such as in direct sunlight, near a fire, etc. There
is danger of explosion.
Do not combine together different types of batteries or new and old batteries.
Do not throw batteries into normal household waste. Take the batteries to a designated
collection place.
Note:
When you connect the power cord, the batteries are automatically disconnected.
Headphones jack
Use headphones with s 3,5 mm connector. Plug the headphones connector into the jack marked with symbol
. When you connect headphones, the speaker of the device automatically shuts off.
Turning the device on and volume control
Turn the device on by turning the VOLUME control (7) to MIN position. The indicator (6) lights up.
Turn the device off by turning the VOLUME (7) control to OFF position. When the device is not used, unplug
it.
Set the volume to desired level by turning the VOLUME (7) control.
Listening to the radio
1.
Using the bandswitch (3) Select the desired waveband.
FM: Short wave, AM: medium wave, LW: long wave.
GB
15

Publicidad

Tabla de contenido
loading

Tabla de contenido