Installation And Connection; Remedy Of Faults; Maintenance And Cleaning - Neptun Premium Classic NCTP-O 300i Instrucciones De Uso

- GB -

Installation and connection

Attention! Dangerous electrical voltage.
Possible consequences: Death or serious injuries due to operation of this unit in a swimming pond.
Protective measures:
• Do NOT use this unit in a swimming pond.
• Adhere to national and regional regulations.
4. How to proceed:
0.
B
1. Set the flow rate:
− Turning the socket clockwise: Increases the flow rate.
− Turning the socket counterclockwise: Decreases the flow rate.
2. Fit the hose onto the outlet.
C
3. Install the pump fully submerged.
− Ensure that the maximum permissible submersion depth of 1 m is not exceeded
− Route the power cable so that it forms a loop below the power socket.
Start-up
NEVER allow the pump to run dry!
Possible consequences: The pump will be destroyed.
Protective measures:
• Ensure that the pump is always fully submerged in the water.
• Regularly check the water level.
• Switching on: Insert the power plug into the socket.
− The unit switches on immediately.
• Switching off: Disconnect the power plug.

Remedy of faults

S
Malfunction
The unit does not start up
Insufficient fountain height

Maintenance and cleaning

Attention! Dangerous electrical voltage.
Possible consequences: Death or severe injury.
Protective measures:
• Electrical units and installations with a rated voltage of U > 12 V AC or U >30 V DC located in the water:
Isolate the units and installations (switch off and disconnect from the power supply) before reaching into the
water.
• Isolate the unit before starting any work.
• Secure the unit to prevent unintentional switching on.
If necessary, clean the unit with clear water using a soft brush.
• Never use aggressive cleaning agents or chemical solutions. These could attack the housing surface or impair the
function.
• In the event of stubborn furring (calcium deposits), a common household cleaner free from vinegar and chlorine can
be used. Subsequently, clean the pump thoroughly using clear water.
10
GA_Bauhaus NCTP-O 300i.pdf 10
Cause
No mains voltage
Impeller unit blocked
Regulator closed too far
Pump casing or impeller unit soiled, hose
blocked
Hose defective
Hose kinked
Impeller unit worn
Remedy
Check the mains voltage
Clean
Adjust regulator
Clean
Replace
Route hose in a straight line
Replace impeller unit
17.02.2014 17:17:30