Find Optimal Feeding Rate; Configure Feeding Rate Sets - Mettler Toledo LV12 Instrucciones De Manejo

4.4 Find optimal feeding rate

The test mode allows you to find the optimal feeding rate and therefore to ensure, that only one part at
a time is fed to the balance. Proceed as follows to adjust the feeding rate using the test mode:
§
The device is in state "ready" (LED Ready is lit up).
1 To enter the test mode, press and hold the button Feed
Rate/Test for at least 5 seconds.
ð The LV12 starts delivery until a part passes through the
light barrier. It then stops for 2.5 seconds and then
continues delivery until the next passage through the
light barrier.
2 By briefly pressing the button Feed Rate/Test, you can now
select the rate so that only one part at a time falls onto the
balance.
3 To quit the test mode, press the button Start/Stop/
Discharge.

4.5 Configure feeding rate sets

During the configuration, the intensity level is indicated by the four green LEDs as follows:
To configure the feeding rate set, proceed as follows:
§
The device is in state "ready" (LED Ready is lit up).
1 Press and hold the two buttons for at least 5 seconds.
ð The LED Ready goes out.
2 Change the feeding rate set by toggling using the button
Feed Rate/Test.
3 To quit the setting mode, press anew the two buttons.
ð The LED Ready is lit up.
Automatic Feeder
General (for most parts, factory
settings)
Midsize parts
Small parts
Large parts
Operation 17