Barrel Blocking Device Installation Instructions - Tippmann TMC Serie Manual Del Usuario

This is not a toy. Misuse may cause serious injury or
death. Eye, face, and ear protection designed for paintball
must be worn by the user and any person within range.
We recommend you be at least 18 years old to purchase.
Persons under 18 must have adult supervision when using
this product. Read this Owner's Manual before using this
product.
Always keep the barrel blocking device installed except when
your marker is in use. Always make sure that the Safety
Selector Switch is in the Safe mode (see instructions on page
6) and the barrel blocking device is properly installed on your
marker according to the instructions to prevent damage to
property, serious injury, or death.

Barrel Blocking Device Installation Instructions

1. Place the barrel blocking device onto the Barrel and position the cord at the under the
Charging Handle as shown.
2. Adjust the cord length retainer up to the back of the Charging Handle by pulling the
cord through it until
the retainer is snug
against the back of
the Charging Handle.
Keeping the cord as
tight as possible, leave just
enough cord elasticity to remove the barrel
blocking device for fi ring.
3. After the cord length is properly adjusted, lock the cord length by tying a knot in the cord
against the back of the retainer as shown.
4. Before and after playing, inspect the barrel blocking device. Replace the barrel blocking
device if the device or cord is damaged, or there is a loss of cord elasticity.
5. Clean the barrel blocking device with plain, warm water and store out of sunlight in a dry
area when not in use.
TP04405 | TMC 68 Caliber Owner's Manual | Rev. 04/18
WARNING
WARNING
B B D
ARREL LOCKING EVICE
E
N
G
L
I
S
H
5