On/Off Switch; Settings On The Machine; Scope Of Application - Festool PRECISIO CS 70 EBG Manual De Instrucciones Original

6.2c Installing the preset profile setting rail
Push the handle of the preset profile setting rail
into the zero position (fig. 15). Tighten the screw
[3-6] (fig. 3) and attach it to the table.
6.3 Transportation
When transporting the power tool, hold it
by the handle areas on the sides [1-13].
Never take hold of or transport the power
tool by the protective cover.
fClick the saw unit into place in the zero posi-
tion.
fRemove all attachments from your saw and
wind the cable around the cable holder.
fFold up the legs if necessary.
6.3a Transport rollers
The machine is equipped with transport rollers
for moving it over short distances.
fTake hold of the power tool by the handle area
[1-13] and pull it to the desired place.
6.4

On/off switch

L
We recommend using a 16 A fuse because of
the high power of the motor.
fTo switch the machine on: Press the green
"On" switch [1-2]. The red button is the "Off"
switch.
7

Settings on the machine

WARNING
Risk of accident, electric shock
fAlways disconnect the mains plug from the
socket before performing any work on the
machine.
7.1 Electronics
The machine has full-wave electronics with the
following properties:
Smooth start-up
The electronically controlled smooth start-up
function ensures that the machine starts up
smoothly.
Speed control
The speed (CS 70 EBG only) can be set anywhere
between 2000 and 4200 rpm using the adjusting
wheel [2-1]. This enables you to optimise the
cutting speed to suit the respective material.
28
CS 70 EBG only
# n [rpm]
0
1 ~ 2000
2 ~ 2400
3 ~ 2800
The preselected motor speed is kept constant
through electronic control. This ensures a uni-
form cutting speed even when under load.
Overload safety device
The power supply is restricted if the machine
is overloaded to extremes. The power supply is
disconnected completely if the motor jams for
some time. You will need to remove the load and/
or switch off the machine before you can use it
again.
Temperature cut-out
The power supply is restricted and the speed
reduced if the motor exceeds a certain temper-
ature. The machine continues operating at re-
duced power to allow the ventilator to cool the
motor quickly. The machine starts up again au-
tomatically once the motor has cooled sufficiently.
Brake (CS 70 EBG only)
The saw blade is stopped electronically with-
in 3 seconds of switching off the machine.
Restart protection
The built-in undervoltage release prevents the
machine from starting up again automatically
if the power is disconnected during continuous
use.
The machine will need to be switched back on if
this happens.
8

Scope of application

The machine can be used as a table saw or as a
circular trimming saw.
8a Table saw (fig. 1)
fFirst release the saw lock by turning the rotary
knob [2-6] anticlockwise.
fThen pull the saw forward using the same
rotary knob [2-6].
fYou can push the notch lever [1-9] down after
a few millimetres.
fIf the saw continues to slide back, the notch
lever will engage in the guide rod and fix the
saw in the centre of the table.
# n [rpm]
0
4 ~ 3300
5 ~ 3800
6 ~ 4200