DeWalt DW735 Manual De Instrucciones página 5

• Make certain that the switch is in the OFF position before con-
necting plug to a power source.
• Be sure that the cutter knives are mounted as described in the
instruction manual and check that all bolts are firmly tightened
before connecting unit to power source.
• To avoid injury, never rotate the cutter block directly with your
hands.
• Keep guards in place and in good working order.
• Stay alert – never operate the unit when tired or under the influ-
ence of drugs, alcohol, or medication.
• Do not use in dangerous environments. Do not use near flam-
mable substances, in damp or wet locations, or expose to rain.
• Never plane material which is shorter than 12 inches.
• Exhaust chute: remove shavings with brush or vacuum after
power has been shut off and cutter head has stopped rotating.
• ALWAYS LOCATE PLANER WITH PROPER CLEARANCE
ON THE OUTFEED SIDE of the unit to prevent pinching or
binding of the workpiece against any obstacle.
• Clean out your tool often, especially after heavy use. Dust
and grit containing metal particles often accumulate on interior
surfaces and could create a risk of serious injury, electric shock
or electrocution. ALWAYS WEAR SAFETY GLASSES.
WARNING: For your own safety, it is recommended that two
people carry this machine or serious injury could result.
CAUTION: Wear appropriate personal hearing protection
during use. Under some conditions and duration of use, noise
from this product may contribute to hearing loss.
WARNING: Some dust created by power sanding, sawing,
grinding, drilling, and other construction activities contains
chemicals known to cause cancer, birth defects or other repro-
ductive harm. Some examples of these chemicals are:
• lead from lead-based paints.
• crystalline silica from bricks and cement and other masonry
products.
• arsenic and chromium from chemically-treated lumber (CCA).
Your risk from these exposures varies, depending on how often you
do this type of work. To reduce your exposure to these chemicals:
work in a well ventilated area, and work with approved safety equip-
ment, such as those dust masks that are specially designed to filter
out microscopic particles.
• Avoid prolonged contact with dust from power sanding,
sawing, grinding, drilling, and other construction activities.
Wear protective clothing and wash exposed areas with
soap and water. Allowing dust to get into your mouth, eyes, or
lay on the skin may promote absorption of harmful chemicals.
CAUTION: A dust mask or respirator should be worn by all per-
sons entering the work area. The filter should be replaced daily or
whenever the wearer has difficulty breathing. See your local hard-
ware store for the proper NIOSH/OSHA approved dust mask.
• The label on your tool may include the following symbols. The
symbols and their definitions are as follows:
V ..........volts
Hz ........hertz
min ......minutes
....direct current
........Class II Construction
........safety alert symbol
Specifications
Input ......................120V AC
No load speed ......10,000 RPM
Feed speed ............14 ft. per minute or 26 ft. per minute
Planing height ........Maximum 6", Minimum 1/8"
3
A ..........amperes
W ..........watts
........alternating current
n o..........no load speed
........earthing terminal
.../min....revolutions per minute
, 15 Amp