Battipav MAGIK Manual De Instrucciones página 19

Battipav srl
CAUTION
After removing the blade, clean the blade flange
thoroughly and check for wear.
Lubricate surfaces with fine oil, then fit the blade.
CHECK DAMAGED PARTS
Before further use of tool, it should be carefully
checked to determine that it will operate properly and
perform its intended function.
For diamond blade disassembly, perform the
opposite operations.
CONNECTING TO POWER SUPPLY
CAUTION
The machine is to be connected to the power supply
by a residual current circuit breaker (RCCB) with the
following characteristics:
RCCB
N.B. To ensure correct functioning, periodically
check the efficiency of RCCBs by pressing the
push-button on the front of the device.
• Make sure that the section of the power supply
cable cores has been measured according to the
starting current and its length.
For cables up to 50 m long, a section of 2.5 mm
is enough.
• Before connecting the machine to the power
socket, check that the power supply voltage
corresponds to that shown on the plate on the
machine.
• The machine must be connected to an effective
earth wire. In case of doubt, do not connect the
machine.
In 10 A Id 30 mA
2
CUTTING ON THE TABLE
CAUTION
6 BEFORE STARTING
OPERATIONS, THE OPERATOR MUST MAKE
SURE THAT AT LEAST 150 cm ARE LEFT FREE
AROUND THE MACHINE (See picture 6).
IN ORDER TO WORK IN SAFETY CONDITIONS,
DO NOT LET OTHER PEOPLE REMAIN NEAR
THE MACHINE
OPERATIONS.
CAUTION
BEFORE PERFORMING THE CUTTING OPERATIONS,
MAKE SURE THAT THE MATERIAL IS PROPERLY
LEANED AGAINST THE TILE STOPPER.
CAUTION
Position the cutting guide, then lock it by tighten the
knobs fully.
CAUTION
7 Figure 7 shows the correct hand position during
90° cutting operations.
The forward movement of the piece must be
proportional to the blade cutting capacity,
to prevent hazardous fragments which could cause
accidents or injuries from breaking off.
CAUTION
CHECK THE WATER LEVEL
THE CUTTING
DURING THE CUTTING
GB
19