Power Stroke PS80519 Serie Manual Del Operador página 12

WARNING:
Do not attempt to modify this product or create acces-
sories not recommended for use with this product. Any
such alteration or modification is misuse and could result
in a hazardous condition leading to possible serious
personal injury.
WARNING:
To prevent accidental starting that could cause serious
personal injury, always disconnect the engine spark plug
wire from the spark plug when assembling parts.
TOOLS NEEDED
See Figure 2.
 Combination wrench
 Phillips screwdriver
ATTACHING THE WHEEL ASSEMBLY
See Figure 3.
 Locate the axles, hitch pins, and wheels. Remove the
hitch pins from the axles.
 Slide the axle through the hole in the center of the wheel.
 Lift the machine and slide the combination into the wheel
mounting hole in the machine base as shown.
 Push the hitch pin into the hole on the end of the axle to
secure the wheel assembly.
NOTE: The hitch pin should be pushed into the axle until
the center of the pin rests on top of the axle.
 Repeat with the second wheel.
INSTALLING HANDLE AND TRIGGER HANDLE
HOLDER
See Figures 4 - 5.
CAUTION:
Be careful to avoid pinching your fingers or hands when
installing the handle onto the frame.
Installing handle:
 Align the handle with the holes in the frame.
 Push and hold the button on the handle as you slide the
handle into the holes in the frame.
Installing trigger handle holder:
 Align trigger handle holder with holes in handle, as shown.
 Install screws and tighten securely.
ASSEMBLY
ATTACHING DETERGENT INJECTION HOSE
See Figure 6.
Before detergent can be used with this machine, the deter-
gent injection hose must be attached.
 Push the open end of the clear detergent injection hose
securely over the fitting as shown.
NOTE: Keep hose away from hot surfaces.
 Place the filtered end of the detergent injection hose in
the bottle of detergent.
CONNECTING THE SPRAY WAND TO THE
TRIGGER HANDLE
See Figure 7.
 Place the threaded end of the spray wand in the connector
on the end of the trigger handle.
 Turn the connector clockwise until it stops. This secures
the spray wand in place.
CONNECTING HIGH PRESSURE HOSE TO
TRIGGER HANDLE
See Figure 8.
 Screw the collar on the high pressure hose into the trigger
handle inlet coupler by turning the hose collar clockwise.
Tighten securely.
NOTE: Be careful to avoid cross-threading, which can
cause the trigger handle to leak during use.
 Pull on the hose to be certain it is properly secured.
CONNECTING THE HIGH PRESSURE HOSE TO
THE PUMP
See Figure 9.
 Completely uncoil and straighten the high pressure hose
to prevent kinks.
NOTE: See Using the High Pressure Hose in Operation
for more information about using the high pressure hose.
 Align the hose collar to the threaded nipple on the pump.
 Insert the end of the high pressure hose collar into the
threaded nipple.
 Turn the hose collar clockwise to tighten the hose securely
to the pump.
NOTE: Be careful to avoid cross-threading, which can
cause the hose to leak during use.
 Pull on the hose to be certain it is properly secured.
Page 8 — English