Biesemeyer T-Square Manual De Instrucciones página 14

13. After the holes have been drilled in the front and rear table
frame, fasten both front and rear rail to table Fig. 28 using
the 1/4-20 x 1-1/2" long flat head screws, fender washers
and hex nuts (P) provided.
14. Lay guide tube (Q) Fig. 29, on saw table as shown, and
line up the threaded holes (R) in bottom of guide tube with
through holes (S) in the front rail. Guide tube will extend
6" past the rail at both ends.
15. Lay guide tube on front rail and fasten the guide tube to
the front rail using the 1/4-20 x 1/2" long hex screws and
lockwashers provided. NOTE: Where there are two
holes 2-1/2" apart, use only one of the holes.
ASSEMBLY
14
P
FIG. 28
R
S
FIG. 29
Q