Biesemeyer T-Square Manual De Instrucciones página 7

REAR RAIL TO SAW
NOTE: DO NOT USE TEMPLATE TO SET REAR RAIL.
3. Align the two holes in the rear rail with the two holes in
the rear edge of the saw table.
Fasten rear rail to the saw as follows:
4. Thread the two 3/8-24 x 1-1/4" long hex head screw and
lock washer (D), supplied, Fig. 5, through the two holes in
the rail and into the two threaded holes in the saw table.
TABLE LEGS TO TABLE BOARD
ASSEMBLY
5. A s s e m b l e
l e v e l i n g
s c r e w i n t o b o t t o m o f s u p p o r t l e g . F i g . 6
illustrates the foot leveling assembly on the table leg.
Assemble the remaing foot assembly to the other leg in
the same manner. NOTE: Height adjustment will be made
later.
6. Lay the table upside down on the floor or on a bench.
FIG. 5
H
FIG. 6
7
t h e 3 / 8 " j a m
s c r e w ( H ) . T h r e a d
D
G
n u t ( G ) o n t o
l e v e l i n g