Dynafit HOJI Serie Instrucciones De Uso página 4

the ski/walk lever at the back. To guarantee proper closure tension, move the ski/walk
lever into the SKI position.
• ULTRA LOCK STRAP (PRO Version): The Ultra Lock Strap on the upper area of the cuff
is vital for the correct operation and safety of the ski touring boot. PLEASE NOTE: This
strap gives the ski touring boot progressive flexibility when skiing. The function of the
strap correlates to that of a buckle closure system. Thus, it is essential for the strap to
be closed when skiing.
• VELCRO STRAP (PX Version): For the PX Version, thread the Velcro strap through the
metal ring. By pulling on the Velcro and the attached connection, you can achieve a
normal adjustment.
• HOJI LOCK SYSTEM Using the rear lever, you can move between the ski and walk
mechanisms with one simple movement. In addition, the PRO Version allows you via a
screw adjustment to compensate for any possible slippage caused by wear and tear of
the components.
NOTE: The ski touring boot is delivered from the factory with the minimum setting.
Only change the screw adjustment if needed and upon the assistance and advice of an
authorized retailer.
USE:
ENTERING AND ADJUSTING
1. Open the buckles and lever, and pull open the tongue on the cuff. Check to see if the
ski/walk lever is in the "walk" position with the lever in the upper position.
2. If not yet done, place the boot liner into the shell. Take care that the sealing gasket
(the piece between the spoiler and shell made of synthetic materials) is not crunched
or compressed.
3. Now pull on the boot: Place your foot in it and adjust the tongue back into the correct
position.
4. Close the lower buckle.
5. Close the ratcheting buckle at the instep.
6. Move the ski/walk lever into the "ski" position with the level in the lowest downward
position.
7. Now adjust the fit of the cuff buckle.
8. Close the Ultra Lock Strap i.e. attach the Velcro strap.
9. Place the ski/walk lever into the "walk" position with the lever in the uppermost position.
• WALK MODE After you have fine-tuned all of the fit adjustments as described in the
section "Entering and Adjusting," move the ski/walk lever into the "walk" position with
the lever in the uppermost position.
• SKI MODE After you have fine-tuned all of the fit adjustments as described in the section
"Entering and Adjusting," move the ski/walk lever into the "ski" position with the lever in
the lowest downward position. Do a few bending movements to facilitate the procedure.