When The Work Is Done; Changing The Dust Bag - Siemens VSZ3 Serie Instrucciones De Uso

en de
18
Figure
The appliance can also be carried using one of the
two handles, for example when vacuuming steps.

When the work is done

19
Figure
Unplug the vacuum cleaner.
Tug the power cord briefly and let go. The cable then
rewinds automatically.
20
Figure
To store or transport the vacuum cleaner, use the
storage aid on the underside of the vacuum cleaner.
Stand the vacuum cleaner up on its end. Slide the
catch on the floor tool into the groove on the
underside of the appliance.

Changing the dust bag

Replacing the dust bag
21
Figure
a)If the dust bag change indicator is completely yellow
when the floor tool is lifted from the floor and the
highest suction power is selected, the dust bag must
be changed, even if it is not yet full. Even if the dust
bag is not full, it may still need changing, due to the
type of dust which has been vacuumed.
First check that the nozzle, suction pipe and flexible
tube are not blocked, as this would also lead to dust
bag change indicator being triggered.
b)The handle can easily be detached from the hose to
remove blockages.
22
Figure
Open the lid by moving the locking lever in the
direction of the arrow.
23
Figure
a)Seal the dust bag by pulling the sealing plate, and
remove the bag.
b)Slide the new dust bag into the holder up to the
stop.
!
Caution: the lid will only close if a dust bag has been
inserted.
Cleaning the motor protection filter
The motor protection filter should be cleaned regularly
by knocking out the dirt and rinsing.
24
Figure
Open the dust bag compartment lid (see Fig. 22).
Pull out the motor protection filter in the direction of
the arrow.
Clean the motor protection filter by tapping it out.
If it is very dirty, the motor protection filter should
be rinsed. The filter must then be left to dry for at
least 24 hours.
After cleaning, slide the motor protection filter into
the vacuum cleaner and close the dust bag
compartment lid.
8
Replacing the micro-hygiene filter
This should be replaced with every replacement filter
pack
25*
Figure
Open the dust bag compartment lid (see Fig. 22).
Release the filter holder by moving the locking lever
in the direction of the arrow.
Remove the micro-hygiene filter. Insert the new
micro-hygiene filter into the appliance.
Insert the filter holder into the appliance until it
engages.
Replacing the micro/activated carbon filter
If your appliance is equipped with a micro/activated
carbon filter, this should be replaced every six months.
26*
Figure
Open the dust bag compartment lid (see Fig. 22).
Release the filter holder by moving the locking lever
in the direction of the arrow.
Remove the micro active carbon filter.
Insert the new micro active carbon filter.
Insert the filter holder into the appliance until it
engages.
Replacing the HEPA filter
If your appliance is equipped with a HEPA filter, this
should be replaced once a year.
27*
Figure
Open the dust bag compartment lid (see Fig. 22).
Release the Hepa filter by moving the locking lever in
the direction of the arrow and remove it from the
appliance.
Insert the new HEPA filter until it engages.
After vacuuming fine dust particles, clean the motor
protection filter and, if necessary, replace the micro-
hygiene filter, micro/activated carbon filter or HEPA
filter.
Care
Always switch off the vacuum cleaner and disconnect
the power cord from the mains before cleaning the
vacuum cleaner. The vacuum cleaner and plastic
accessories can be cleaned with a commercial plastic
cleaner.
!
Do not use a scourer, glass-cleaning agent or all-
purpose cleaning product. Never immerse the
vacuum cleaner in water.
The dust compartment can, if necessary, be cleaned
with a second vacuum cleaner or simply wiped with a
dry cloth or dusting brush.
Subject to technical modifications.