z Fit the connection cable to the mains lead cleat. Do not allow to
rub against edges or against sharp or pointed objects. Do not
squeeze cables through tight door or window openings. Switch
devices must not be removed or circumvented (e.g. connecting
the switch lever to the handle bars)
When mowing
z Do not tilt the lawnmower when switching on the motor, unless
the lawnmower has to be tilted when starting. If that is the case,
do not tip the lawnmower more than absolutely necessary, and
only lift the part furthest removed from the user. Always ensure
that both hands are in the operating position before replacing the
lawnmower on the ground.
z Caution, danger! Cutting gear will continue running!
z Maintain the safety distance prescribed by the handle bars.
z Only switch on the motor if your feet are at a safe distance from
the cutting gear.
z Take care to ensure a safe and stable position, especially on slo-
pes. Never run; always walk calmly forward.
z Always mow slopes at right angles to the incline; never mow up
and down.
z When mowing slopes, be especially careful when changing direc-
tion.
z Never mow steep slopes.
z Be especially careful when mowing backwards and pulling the
lawnmower towards you.
z Switch the mower off when tilting it, running on empty or trans-
porting the lawnmower, e.g. to/from a lawn or along paths.
z Never use the lawnmower if safety devices are faulty or missing,
such as deflector and/or grass catchment devices.
z Caution: do not touch running cutters.
z Always keep hands and feet away from rotating parts. Do not
stand in front of the grass ejector opening.
z Never lift or carry a lawnmower while the motor is running.
z Never open the guard flap while the motor is still running.
z Before removing the grass catchment device, turn off the motor
and wait until the cutting gear has stopped running. After empty-
ing the grass catchment device, reattach carefully.
z Never drive across gravel while the motor is running – impacting
stones!
z Avoid mowing wet grass where possible.
Assembly
Fasten handle bars
A
1
Caution!
The cable can be damaged while folding up or pulling out
the handle bar.
z Inlay the cable in the bend protection.
z See illustrations.
Operation
General
Operating times
z Please check noise abatement regulations prevailing in your
country.
G
B
C
z Switch off the lawnmower, pull the mains plug and wait for the
lawnmower to stop running if, for example:
–
leaving the lawnmower
–
unblocking a blade
–
intending to check, clean or work on the lawnmower
–
you have encountered a foreign object, in which case you
should check the lawnmower for damage and carry out any ne-
cessary repairs.
–
the lawnmower is vibrating heavily (switch off immediately and
ascertain the cause).
–
you wish to change the settings or carry out cleaning work.
–
you wish to check whether the connection cables have become
tangled or damaged.
–
If the connection cable is damaged during use, it must be im-
mediately disconnected from the mains power supply.
Do not touch the cable before it has been disconnected from
the mains power supply.
Maintenance
1
Attention! Rotary cutter blade
Before all maintenance and cleaning work:
z Pull out the power plug.
z Do not touch running blades.
z Never spray down the lawnmower using water, especially not at
high pressure.
z Regularly check and tighten all visible screws and nuts, espe-
cially those relating to the cutting bar, to ensure a firm fit.
z Always have blades changed or re-sharpened by a specialist
workshop, since a balance test must be carried out as specified
in the safety regulations following any removal of parts.
z Only use original WOLF-Garten spare parts. Otherwise we can't
guarantee that your mower conforms to the safety regulations.
z Never park your lawnmower in damp rooms.
z For safety reasons, replace worn or damaged parts.
Disposal
Do not dispose of electrical equipment in domestic
waste. Recycle equipment, accessories and pa-
ckaging in an environment-friendly manner.
Mount the collecting bag
z See illustrations.
Feed cable through the strain relief
z Please feed cable through the strain relief
3
Note: WOLF-Garten Flick-Flack®
WOLF-Garten Flick-Flack® keeps the cable away from the cut-
K
ting unit
(2).
D
E
F
G H
J
K
K
(1).
11