Quick Clamping Nut; Starting Operation; Switching On And Off - Bosch PWS 550 Instrucciones De Servicio

Ocultar thumbs Ver también para PWS 550:
Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 29

Quick Clamping Nut

(for M 14 grinder spindle)
Instead of the clamping nut 10, the quick-clamp-
ing nut 11 (accessory) can be used. Grinding
tools can then be mounted without using tools.
The quick-clamping nut 11 may be used only
for grinding and cutting discs.
Use only a flawless, undamaged quick-clamp-
ing nut 11.
When screwing on, take care that the side
with printing does not point to the grinding
disc. The arrow must point to the index
mark 20.
20
11
3
3
Approved Grinding Tools
All grinding tools mentioned in these operating in-
structions can be used.
The permissible speed [rpm] or the circumferen-
tial speed [m/s] of the grinding tools used must at
least match the values given in the table.
17 • 2 609 000 850 • 06.01
Lock
the
grinder
spindle with the spin-
dle
lock
button 3.
Tighten the quick-
clamping
nut
by
forcefully turning the
grinding disc in the
clockwise direction.
A properly tightened
undamaged,
quick-
clamping nut can be
loosened by hand
turning the knurled
ring by hand in an an-
ticlockwise direction.
Never loosen a tight
quick-clamping nut
with pliers but use a
two-pin spanner. In-
sert
the
two-pin
spanner as shown in
the illustration.
English - 6
Therefore, always observe the permissible
rotational/circumferential speed on the label
of the grinding tool.
max.
[mm]
D
100
d
115
D
125
b
100
D
115
125
d
70
b
75
D

Starting Operation

Observe correct mains voltage: The voltage of
the power source must agree with the voltage
specified on the nameplate of the machine.
Equipment marked with 230 V can also be con-
nected to 220 V.

Switching On and Off

To start the machine, press the On/Off switch 1
forward.
To lock-on, press the On/Off switch 1 down at
the front until it engages.
To switch off the machine, release the On/Off
switch 1 or, when the switch is locked, briefly
press down the On/Off switch 1 at the rear.
Test run!
Check the grinding tool before use. The
grinding tool must be properly mounted
and rotate freely. Perform a test run of at
least 30 seconds without load. Do not use
damaged, out-of-round or vibrating grind-
ing tools.
Constant Electronic Control
(PWS 8-125 CE/PWS 9-125 CE)
Constant electronic control holds the speed con-
stant at no-load and under load, and ensures uni-
form working performance.
Overload Protection
(PWS 8-125 CE/PWS 9-125 CE)
When overloaded, the motor comes to a stop.
Relieve the load on the machine immediately and
allow to cool for approx. 30 seconds at the high-
est no-load speed.
[mm]
b
d
[rpm]
6
16.0
11 000
6
22.2
11 000
6
22.2
11 000
11 000
11 000
11 000
30
M 10
11 000
30
M 14
11 000
[m/s]
80
80
80
80
80
80
45
45

Publicidad

Tabla de contenido
loading

Tabla de contenido