Cleaning And Storage - Clatronic DB 3016 Instrucciones De Servicio

6. Only connect the machine to a properly installed safety socket, 230 V/50 Hz.
7. The control lamp (2) lights up. As soon as it shuts off, the set temperature is reached.
Now you can start to iron.
8. Always pull the plug out of the socket after using the iron.
Steam Ironing ( )
A higher temperature is required for this (wool, cotton, linen).
The quantity of steam can be regulated using the steam quantity regulator (4).
Extra steam can be added with the steam jet function (3).
When ironing at low temperatures, make sure that you reduce the quantity of steam or iron
without steam. If the temperature is too low water may leak from the soleplate.
Refi lling the water tank
• Always disconnect the mains plug before refi lling water.
• Set the steam control (4) to "0" (no steam). Open the lid of the refi ll inlet (6) and carefully
pour in the water. Do not exceed the maximum line as marked on the water reservoir.
Spray Function ( )
GB
In order to moisten a section to be ironed press the spray button (5).
Vertical Steam
This can be used to produce a jet of steam in a vertical direction.
Note: To avoid excess water leaking from the soleplate do not operate the steam burst for
more than 5 seconds without interruption.
• Always remove the mains lead before cleaning!
• Clean the casing with a slightly damp cloth.
• Clean the iron with a slightly humid cloth.
• Always return the steam regulator to the „0" position after use and empty the water tank
in order to prevent any leaks.
40
05-DB 3016 40
0 No steam
1 Small steam volume
2 Large steam volume
Caution: the steam is hot. Danger of scalding!

Cleaning and Storage

12.04.2006, 11:03:45 Uhr