G-Lab GENEVA Cinema Manual Del Usuario página 8

tv sEtup
ovErviEW
Check your TV's output connectors. Depending on the available connector, select one of the configurations below.
Once the Model Cinema has been turned on, press
automatically select the correct TV inputs. If the TV has both analog and digital audio outputs, then the digital audio is recommended to ensure the
best audio quality.
tv with digital audio output ( optical / toslink )
1. Connect a fiber optic cable from your TV ( small square connector
with a red light inside ) to the Model Cinema ( connector "OPTICAL" ).
2. To change the audio output from your TV's speakers to its audio
output connector, you need to select "External Speakers" on your
TV setup menu.
tv with digital audio output ( coaxial / spdiF )
1. Connect an audio cable from your TV ( single RCA connector ) to
the Model Cinema ( connector "COAXIAL" ). The audio cable has a
single RCA connector on both sides.
2. Select "External Speakers" on your TV setup menu.
tv with analog audio output
1. Connect an audio cable from your TV ( dual red & white RCA
connector or 3.5 mm connector ) to the Model Cinema ( connector
"ANALOG" ).
2. Select "External Speakers" on your TV setup menu.
tv with headphone output
1. Connect an audio cable from your TV headphone output ( 6.35 mm
or 3.5 mm connector ) to the Model Cinema ( connector "ANALOG" ).
6
on the Model Cinema remote control. The TV setup is very easy: the Model Cinema will
2. Normally the audio on the TV speakers is automatically turned off, if
you insert a connector into the headphone output. In this case, you
don't need change any settings on the TV.