Waeco PerfectView REC 400 Instrucciones De Montaje página 28

Safety instructions
People (including children) whose physical, sensory or mental
capacities prevent them from using this device safely may not
be allowed to operate it without the supervision of a responsible
adult.
Electrical devices are not toys
Always keep and use the device out of the reach of children.
Children must be supervised to ensure that they do not play with
the device.
A NOTICE!
Before start-up, check that the voltage specification on the type
plate is the same as that of the power supply.
To prevent the risk of short circuits, always disconnect the neg-
ative terminal of the vehicle's electrical system before working
on it.
If the vehicle has an additional battery, its negative terminal
should also be disconnected.
Therefore, please observe the following instructions:
When working on the following cables, only use insulated cable terminals,
plugs and flat sockets:
– 30 (direct supply from positive battery terminal)
– 15 (connected positive terminal, behind the battery)
– 31 (return cable from the battery, earth)
– L (indicator lights, left)
– R (indicator lights, right)
Do not use porcelain wire connectors.
Use a crimping tool to connect the cables.
Screw the cable when connecting cable 31 (earth)
– using a cable terminal and serrated washer to one of the vehicle's
earth bolts or
– screw the cable to the bodywork using a cable terminal and a self-tap-
ping screw
Make sure there is a good earth connection.
If you disconnect the negative terminal of the battery, all data stored in the
volatile memories will be lost.
The following data must be reset, depending on the vehicle equipment op-
tions:
– Radio code
– Vehicle clock
28
PerfectView REC 400
EN