Application Menus - Tasco 780200T Manual De Instrucciones

2. To take a still photo, go to the Capture menu and select "Still Image Capture". This
opens a new window showing the captured photo. This window has its own File
menu-select Save to store the photo in the folder you choose in the previous step
(you can rename the photo, or accept the default file name). Select Exit to close the
capture preview window. Note-you can also take a still photo by pressing the Capture
button on the front of the microscope tube (just below the green light). However,
it may be difficult to avoid handling vibration, resulting in blurry photos-especially
above 10x magnification settings.
3. To capture a video clip, select "Start Capture" to begin recording a video clip. Recording
will automatically stop when the time limit is up (to change the default time, select
"Record time limit" in the Capture menu), or you can manually stop recording video
sooner by clicking the "Capture" menu again and selecting "Stop Capture". The .avi
video clips are saved to the folder you set up in step #6 above.
4. That's it! When finished using the application, select "Exit" in the File menu. If you want
to make adjustments to the still photo or video image quality (this is normally not
necessary to obtain good results), explore the options found in the application menus
under Option>Video Capture Filter, Option>Video Capture Pin, and Capture>Set
Frame rate. These are described in the following Application Menus section.

APPLICATION MENUS:

File
• Set capture file Folder
after selecting "Start Capture" in the Capture menu
• Set snapshot file Folder
(created after selecting "Still image Capture" in the Capture menu
• File index reset
name will be replaced with newer ones.
• Exit
-quit application
Device
: the "USB PC Camera" (your microscope) should be the only device currently using
the driver, so normally there is no need to use this menu. However, if you are not getting
an image from the microscope (assuming it is connected properly), make sure that "USB PC
Camera" is checked in this menu.
• USB PC Camera
Option
• Preview
-leave checked normally. Unchecking and checking again will refresh the "live"
image from the camera.
• Video Capture Filter
horizontally ("mirror") or vertically, view the image in black & white, adjust the color
saturation, sharpness and brightness and other variables. Note any adjustments you
make here will also affect captured still images, not just video clips. The "Special Effect"
tab has a variety of entertaining visual effects that can be applied to the microscope
image, as well as a digital zoom slider for additional magnification (the "Zoom Enable"
box must be checked first).Click "Reset" to restore the original default settings. Click
"Apply" to see the Preview image with your current settings. Click OK to keep and switch
to your new settings. Click "Cancel" to leave this screen without making any changes.
USING the MICROSCOPE
-allows you to specify default location for video files (created
-allows you to specify default location for still photo files
-starts file numbering over with "Still0001" etc. Previous files with same
-options in the "General Setting" tab allows you to flip the image
10