Connecting The External Components With The System - Yamaha MCS-1330 Manual De Instrucciones

CONNECTING THE EXTERNAL COMPONENTS WITH THE SYSTEM

Make sure you read the following procedure and notes carefully before connecting the system. For information on the
speakers (NS-BP400), refer to the owner's manual supplied with it.
CAUTION
• Do not connect this unit or other components to the main power until all connections between components are complete.
• Do not let the bare speaker wires touch each other or do not them touch any metal part of the receiver. This could damage the receiver
and/or the speakers.
• All connections must be correct: L (left) to L, R (right) to R, "+" to "+" and "–" to "–". If the connections are faulty, no sound will be
heard from the speakers, and if the polarity of the speaker connections is incorrect, the sound will be unnatural and lack bass. Also,
refer to the owner's manual for each of your components.
Right speaker
(NS-BP400)
R
SPEAKERS:6 MIN.
5
4
3
L
2
1
Connecting the system
Connect the CD (L/R) jacks of the receiver to the OUTPUT (L/R) jacks of the CD player using the supplied audio
RCA stereo cable.
Connect the SYSTEM CONNECTOR (TO:CD PLAYER) jack of the receiver to the SYSTEM CONNECTOR
(TO:RECEIVER) jack of the CD player using the supplied system control cable.
Connect the speaker terminals (L) of the receiver to the speaker terminals of the left speaker and the speaker terminals (R)
of the receiver to the speaker terminals of the right speaker using the speaker cables supplied with the speaker set (NS-
BP400). Also, attach the clamp filter to the speaker cables within 10 cm of the left and right speaker terminals (see page 2).
Notes
• The NS-BP400 speakers are not magnetically shielded, so place the speakers away from the monitor. When connecting speakers other
than NS-BP400, use the speakers having more than 6 Ω impedance.
• The PHONO jacks are only compatible with a turntable with MM cartridge.
• Connect your turntable to the GND terminal to reduce noise in the signal. However, you may hear less noise without the connection to
the GND terminal for some turntable(s).
When using banana plugs (commercially available), tighten the speaker terminals strongly then connect the banana plugs (for U.S.A,
Canada, Australia and China models).
Turntable
GND
Left speaker
L
(NS-BP400)
GND ANTENNA
75 UNBAL. FM
L
L
INPUT
R
PHONO CD AUX
OUTPUT
R
CONNECTING THE EXTERNAL COMPONENTS WITH THE SYSTEM
DVD player etc.
Audio out Audio out
RCA
stereo
R L
cable
GND AM
OUTPUT SYSTEM
CONNECTOR
SUB
WOOFER
TO:CD PLAYER
L
TO:RECEIVER
SYSTEM
CONNECTOR
Subwoofer
INPUT
INPUT
RCA
stereo
R
cable
Receiver (R-1330)
System control
cable (supplied)
RCA stereo cable
(supplied)
CD player (CD-1330)
9
En