Automatic-Power-Switching Function; Adjusting The Subwoofer Before Use; Rear Panel - Yamaha NS-P110 Manual De Instrucciones

Automatic power-switching function
If the source being played is stopped and the input signal is
cut off for 7 to 8 minutes, the subwoofer automatically
switches to the standby mode. (When the subwoofer
switches to the standby mode by the automatic power-
switching function, the power indicator lights up in red.)
When you play a source again, the power of the subwoofer
turns on automatically by sensing audio signals input to the
subwoofer.
This function will operate by sensing a certain level of low
frequency input signal. Usually set the AUTO STANDBY
switch to the LOW position. However, if the power is not
switched on or to the standby mode smoothly, set the switch
to the HIGH position. In the HIGH position, the power will
turn on even with a low level of input signal. But please be
aware that the subwoofer may not switch to the standby
mode when there is an extremely low input signal.

Adjusting the subwoofer before use

Before using the subwoofer, adjust the subwoofer to obtain the optimum volume balance between the subwoofer and the front
speakers by following the procedures described below.
POWER
ON
3
OFF
10
E-

Rear panel

VOLUME
0 10
AUTO
STANDBY
HIGH
LOW
OFF
INPUT
/MONO
POWER
ON
OFF
* The power might turn on unexpectedly by sensing noise
from other appliances. If that occurs, set the AUTO
STANDBY switch to the OFF position and use the
POWER switch to switch the power between ON and
OFF manually.
* This function detects the low-frequency components
below 200 Hz of the input signals (i.e., the explosion in
the action movie, the sound of the bass guitar or the bass
drum, etc.).
* The minutes required to switch the subwoofer to the
standby mode might change by sensing noise from other
appliances.
This function is available only when the power of the
subwoofer is on (by pressing the POWER switch).
VOLUME
0
AUTO
STANDBY
HIGH
LOW
OFF
INPUT
1, 5
10
/MONO