Setting The Milling Head; Setting The Chamfer Width - Unitec SKF 025 Instrucciones De Manejo

Setting the milling head

1
2

Setting the chamfer width

CS Unitec, Inc., 22 Harbor Ave., Norwalk, CT 06850 • Toll-free: 800-700-5919 • Ph: 203-853-9522
Fax: 203-853-9921 • Email: info@csunitec.com • Website: www.csunitec.com
SKF 25
Place the machine onto the upper side (power connecting
‹
cable ).
Release the locking mechanism (2) on both sides of the
‹
machine.
Set the desired milling angle. The milling angle can be
‹
viewed on the scale (1).
Tighten the locking mechanism (2) on both sides of the
‹
machine.
3
2
Place the machine onto the upper side (power connecting
‹
cable ).
Release the locking mechanism (1).
‹
Set the desired chamfer angle by turning the adjusting screw
‹
(3). The chamfer width can be viewed on the scale (2).
Tighten the locking mechanism (1).
‹
1
Setting up
37