Batavus X2 Manual Del Usuario página 4

Thread the brake wire and the console cable into
the front tube so that both go behind the lateral
tube inside front tube. Lead the brake wire out of
the opening for the resistance adjustment knob and
the console wire from the upper end of the front
tube. Push the front tube inside the frame tube:
beware not to damage the console cable! Attach the
front tube with six screws tight.
RESIStANCE ADJUStMENt KNOB
Turn the resistance adjustment knob clockwise to
the extreme position. Thread the flat cabels of the
adjustment knob into the front tube and pull them
out through the top of the front tube. Place the
resistance adjustment knob on its place and attach
it to the front tube with a screw from the other side
of the front tube.
PEDAL CRANKS
4
BATAVUS X2 290806.indd 4
Place the long metal bushing on the left rear
shaft, then the rear end of the left pedal crank.
Next place the short metal bushing, washer and
locking nut on the shaft. Tighten the locking nut
only slightly. Push the plastic end cap on the nut.
Repeat the procedure on the right side.
Push the front end of the left pedal crank inside
the lower end of the left handle. Attach the crank
to the handle with four screws fingertight. Repeat
the procedure on the right side. Tighten the screws
well and push the plastic end caps on the screws.
StAtIONARY HANDLEBAR
Thread the handgrip pulse cables inside the front
tube and pull them out through the top end of the
tube. Attach the stationary handlebar with two
screws. Beware not to damage the cables!
NOtE!
29.8.2006 14:56:05