König Electronic CMP-NWIPCAM22 Manual De Uso página 2

IP Wireless Network Camera
Appearance and Interface
Notes:
Power Indicator: It will turn RED if the equipment is powered on.
Status Indicator: Slow flickering (once every 2 seconds) indicates that the device is searching for a
network; flickering (once or twice per second) indicates that the wired network is connected; frequent
flickering (2 to 3 times per second) indicates that the wireless network is connected.
Equipment Interface
Power Input Socket: Connects to a DC adapter, its output should be 5 V power specification.
RESET Button: If the RESET button is pressed and held for more than 10 seconds, the equipment will
restart and recover to the default factory settings.
WIFI Antenna Hole: Installs the WIFI antenna.
RJ45 Ethernet Socket: The RJ45 Ethernet socket is 10/100M self-adjusting. The equipment can connect
to all kinds of network equipment, such as hub, router, switch, etc.
NOTE: The factory setting IP is 192.168.0.178, the http port is 80, the username is admin, the
password is 123456.
Audio Input Socket: The audio input socket is designed for connecting an external microphone. The
built-in microphone will be invalid when the external microphone is plugged in.
Audio Output Socket: The audio output socket is for a line-out audio player, such as headphone,
speaker, etc.
Alarm Output Socket: The alarm output socket is connected to a relay in the IP camera. The IP camera
will control the switch to trigger the alarm bell or buzzer to alarm. The relay is able to control the switch of
an alarm whose voltage is no more than 36 V and whose current is lower than 2 A. Please refer to Figure
2 for the connection of an external alarm.
ENGLISH
Output pins
Switch
Alarm power
Figure 2
2
Alarm