Intended Use; Installation Site - Galletti ART-U Serie Manual De Instalación, Uso Y Mantenimiento

1 BEFORE STARTING THE INSTALLATION PROCEDURE
Carefully read this manual.
Installation and maintenance should be carried out by technical
personnel qualified for this type of machine, in compliance with
current safety regulations.
When receiving the unit please check its state verifying if any
damage occurred during the transport.
For installation and use of possible accessories please refer to
the pertinent technical sheets.
Identify the model of the ART-U fan coil following the indications
on the packing container. See paragraph 3.7 p. 21.
SAFETY SYMBOLS
Carefully read this manual.
Warning
Use personal protective equipment
USE SUITABLE PPE (GLOVES FOR REFRIGERANT, PROTEC-
TIVE GOGGLES)
WARNING:
Electrical and electronic products may not be
mixed with unsorted household waste. Do NOT try to dis-
mantle the system yourself: the dismantling of the system,
treatment of the refrigerant, of oil and of other parts must
be done by an authorized installer and must comply with
applicable legislation. Units must be treated at a specialized
2

INTENDED USE

Galletti S.p.A. will not accept any liability for damage or injury
caused as a result of installation by non-qualified personnel; im-
proper use or use in conditions not allowed by the manufactur-
er; failure to perform the maintenance prescribed in this manual;

INSTALLATION SITE

When choosing an installation site, you should observe the fol-
lowing rules:
Ū The air conditioning unit should not be placed immediately
under a socket
Ū Do not install the unit in places where inflammable gases or
powders are present
Ū Do not expose the unit to sprays of water; do not install the
unit in laundry room
Ū Install the unit on walls able to withstand its weight. Keep a
clear space all around the unit to assure the proper function-
ing and accessibility for routine and extraordinary mainte-
nance (see figure 11.4 p. 65 )
Ū store the unit in its packing container until you are ready to
install it
18
ART-U
treatment facility for reuse, recycling and recovery. By en-
suring this product is disposed of correctly, you will help to
prevent potential negative consequences for the environ-
ment and human health. For more information, contact your
installer or local authority.
use of spare parts other than original factory parts.
Equipment designed for ambient air conditioning and intended
for use in civil comfort applications.
WARNING: installing the indoor unit on walls that are not
perfectly flat may cause a deformation (twisting) of the unit,
which may compromise the perfect alignment of the com-
ponents and make it difficult to install the cabinet. In some
cases this can even lead to unstable air flow; this situation is
resolved once the problem that is causing the deformation
referred to above has been rectified. Check that the wall is
flat before proceeding with the installation. If the walls are
not flat, it is sometimes possible to remedy this situation by
inserting suitable shims between the unit's mounting slot
and the wall itself, so as to compensate for any unevenness
noted.