Install The Panel - MUNDO CLIMA MUCS 12 HF Manual De Instalación

Four-Way Cassette Type

INSTALL THE PANEL

• Align the swing motor on the panel to the tubing
joints of the body properly. (Chart 11)
• Fix hooks of the panel at swing motor and its
opposite sides to the hooks of corresponding
water receiver. (Chart 11 ) Then hang the other
two panel hooks onto corresponding hangers of
the body. (Chart 11 )
CAUTIONS
Do not coil the wiring of the swing motor into the
seal sponge.
• Adjust the four panel hook screws to keep the
panel horizontal, and screw themup to the ceiling
evenly. ( Refer to chart 11 )
• Regulate the panel in the direction of the arrow in
Chart11 slightly to fit the panel's center to the
center of the ceiling's opening. Guarantee that
hooks of four corners are fixed well.
• Keep fastening the screws under the panel
hooks, until the thickness of the sponge between
the body and the panel's outlet has been reduced
to about 4~6mm. The edge of the panel should
contact with the ceiling well. (Refer to chart 12)
Malfunction described in Chart13 can be caused
by inappropriate tightness the screw.
If the gap between the panel and ceiling still exists
after fastening the screws, the height of the
indoor unit should be modified again. ( Refer to
chart 14-left)
You can modify the height of the indoor unit
through the openings on the panel's four corners,
if the lift of the indoor unit and the drainpipe is not
influenced (refer to chart 14-right).
(4) Hang the air-in grid to the panel, then connect
the lead terminator of the swing motor and that of
the control box with corresponding terminators on
the body respectively.
(5) Relocate the air-in grid in the procedure of
reversed order.
(6) Relocate the installation cover.
a. Fasten the rope of installation cover on the bolt
of the installation cover. (Refer to chart 15-left)
b. Press the installation cover into the panel
slightly. (Refer to chart 15-right)
8
EN